APC 600 user manual Power on button, Power standby button, Test button, Alarm disable button

5.0 Operation

5.1.6 Power on button

The power on button turns on the UPS and energizes the load. Note that the UPS must be enabled (see Sec. 4.3.2). The UPS’s battery charger is always active as long as the UPS is plugged in.

5.1.7 Power standby button

The power standby button turns off the UPS and deenergizes the load. The UPS’s battery charger remains active as long as the UPS is plugged in.

5.1.8 Test button

The Test button initiates a self-test of the UPS’s battery. When you press the Test button, the UPS briefly operates on batteries to determine their strength (the load is not affected). Holding this button for several seconds activates the output power bar graph (see Sec. 5.2).

5.1.9 Alarm disable button

The alarm disable button cancels the On Battery audible alarm (see Sec. 5.4.1). Pressing this button disables the alarm until the next utility failure. Holding this button for several seconds activates the line voltage bar graph (see Sec. 5.3).

16