Royal Sovereign RSS-685, RSS-1050 Check the laminating length & How many laminated papers

Page 17

***STND-BY (Saving Electricity while you are not operating for a while)***

1.	When press ST/BY button	will display
	on the screen and STND-BY mode is set at 80℃.
2.	When machine is in	mode, machine condition
	wouldn’t work. Press the	ST/BY button and
	it will revert to the previous working.
3.	When the machine runs, you can’t change it to the
	mode.
	In this case, press the STOP button and turn
the machine to the		mode.

ST/BY

Check the laminating length & How many laminated papers

1.When press MEANS button the present numbers of length and papers laminated will be shown on

the screen.

2.When you want to return to working mode, Press MEANS button again.

3.Also, you can reset measure mode by pressing RESET button.(for 2 second)

RESET FAN MEANS

- 17 -

Image 17

Contents Royal Sovereign Laminators Table of Contents Introduction Safety PrecautionsDescription RSS-1200 RSS-1050 RSS-685 CharacteristicsSpecifications Names of Major Parts of Machine HOW to Adjust Alignment Adjustment of Film Tension and LocationsHOW to Control Tension Setting UP Film HOT Film Hanging FilmCold Film Methods of controlling pressure of the roller Control of Roller PressureTerms Instructions for Control PanelLCD Window REV Stop RUN Functions of ButtonsSet the upper/ lower heat shoes HOW to USE ButtonsSpeed controls Button & DisplayUse the memorized working condition Memorize working conditionCold mode Check current temperature on the shoesCheck the laminating length & How many laminated papers HOT Laminating Laminating StepsLaminating Speed at each level Useful InformationTemp Speed Temperature/Speed adjustment guideReference Cold LaminatingCross Cutter Tips for Remote Control and Foot SwitchMethod for Using Cutter Slitters Maintenance Important Safety ConcernsIts not out of order Symptom Cause Check pointDuration of Limited Warranty Limited WarrantyMemo