Royal Sovereign RSS-1050, RSS-1200, RSS-685 owner manual Introduction, Safety Precautions

Page 3

INTRODUCTION

Thank you for purchasing a Royal Sovereign Roll Laminator. It has been designed and manufactured to provide years of continuous service in the professional environment. To insure high quality lamination, please read this instruction manual thoroughly.

This manual will provide you with complete operating and maintenance information. For additional product support or factory-direct ordering information.

Call Royal Sovereign Customer Service at (800) 397-1025.

SAFETY PRECAUTIONS

The safety recommendations outlined in this section are to be read, understood and followed before operating machine. Keep this information for future reference. Failure to comply any of the following safety procedures could result in serious personal injury.

1.To prevent the possibility of electrical shock, do not immerse machine in water or permit liquids to spill inside.

2.Do not allow articles of clothing (neckties, scarves, papers, etc.) near front or rear machine openings as they could get caught by rollers and be pulled inside, causing personal injury.

3.Do not insert sharp objects into front or rear machine openings. Do not place anything in feed tray openings of machine other than appropriate laminating materials or pouches.

4.Do not attempt to laminate items that exceed total recommended material thickness.

5.Do not operate machine for any other purposes than its intended use.

6.Do not operate machine if electrical plug or power cord is damaged.

7.Turn off the power when unattended or not in use. Unplug machine before movig it or when it is not in use for an extended period of time.

8.This machine is intended for indoor use only.

9.Do not alter or extend electric plug. Plug is configured for appropriate electrical supply.

10.The socket-outlet shall be installed mear the equipment and shall be easily accessible.

- 3 -

Image 3
Contents Royal Sovereign Laminators Table of Contents Introduction Safety PrecautionsCharacteristics SpecificationsDescription RSS-1200 RSS-1050 RSS-685 Names of Major Parts of Machine Adjustment of Film Tension and Locations HOW to Control TensionHOW to Adjust Alignment Setting UP Film HOT Film Hanging FilmCold Film Methods of controlling pressure of the roller Control of Roller PressureTerms Instructions for Control PanelLCD Window REV Stop RUN Functions of ButtonsButton & Display HOW to USE ButtonsSet the upper/ lower heat shoes Speed controlsUse the memorized working condition Memorize working conditionCold mode Check current temperature on the shoesCheck the laminating length & How many laminated papers HOT Laminating Laminating StepsLaminating Speed at each level Useful InformationTemp Speed Temperature/Speed adjustment guideReference Cold LaminatingTips for Remote Control and Foot Switch Method for Using CutterCross Cutter Slitters Maintenance Important Safety ConcernsIts not out of order Symptom Cause Check pointDuration of Limited Warranty Limited WarrantyMemo