Royal Sovereign RSS-1050 Adjustment of Film Tension and Locations, HOW to Control Tension

Page 6

ADJUSTMENT OF FILM TENSION AND LOCATIONS

Alignment Knob.

Locking Nut

Tension Control Knob

Film필 름

Shoe-Heater

Anti-Wrinkle 방 지 부 device

Film필 름

1. HOW TO CONTROL TENSION

Tension of film can be controlled depending on the state of lamination, but basically you can adjust it, to some extent, and make wrinkles straighten from Anti-Wrinkle Part of the heat shoe. To increase the tension on the film, turn the knob clockwise.

To lower the tension, turn the handle counter clockwise. If lamination is curved upward, it means that tension of upper film is high. In this case, it can be controlled by raising tension of lower film or lowering tension of upper film. If lamination is curved downward, apply the method in reverse.

2. HOW TO ADJUST ALIGNMENT

Location control device is used when the edges of the lamination are unjustified.

As the drawing shows, when the alignment knob is turned clockwise, the upper film is moved to right. On the contrary, when the handle is turned counter-clockwise, it is moved to left. Once proper alignment is reached, turn the Locking Nut tight against the Alignment knob so the adjustment is set.

- 6 -

Image 6
Contents Royal Sovereign Laminators Table of Contents Safety Precautions IntroductionCharacteristics SpecificationsDescription RSS-1200 RSS-1050 RSS-685 Names of Major Parts of Machine Adjustment of Film Tension and Locations HOW to Control TensionHOW to Adjust Alignment Setting UP Film Hanging Film HOT FilmCold Film Control of Roller Pressure Methods of controlling pressure of the rollerInstructions for Control Panel TermsLCD Window Functions of Buttons REV Stop RUNSpeed controls HOW to USE ButtonsSet the upper/ lower heat shoes Button & DisplayMemorize working condition Use the memorized working conditionCheck current temperature on the shoes Cold modeCheck the laminating length & How many laminated papers Laminating Steps HOT LaminatingUseful Information Laminating Speed at each levelTemperature/Speed adjustment guide Temp SpeedCold Laminating ReferenceTips for Remote Control and Foot Switch Method for Using CutterCross Cutter Slitters Important Safety Concerns MaintenanceSymptom Cause Check point Its not out of orderLimited Warranty Duration of Limited WarrantyMemo