2. Slitters
1.This machines has two vertical cutters (slitters) 2. For successive lamination, it is easy to cut
vertically.
3.Fix the cutter at the point to be cut, on the left and right.
(Turn the screw counter clock wise to loosen the slitter, and slide it to the point to be cut. Once the point is set, turn clock wise to fix it.)
4. Turn the cutter knob to "ON".
5.Once you start lamination, it is automatically slit.
6.Dial Cutter knob at "OFF" mode after lamination.
7.When the knife is dull, unscrew the cutter screw to counter clockwise to take the knife out.
Break the edge of knife and tighten the screw.
**CAUTION.**
*When you do not use vertical cutter, please set the both cutter at the bottom of each side. It could cause you to cut your hands while installing roll film.
- 23 -