HANGING FILM
1. HOT FILM
|
|
| UPPER | ROLL FILM | |
HEAT | SHOE |
|
|
| SHAFT |
LOWER IDLE BAR |
|
|
|
| |
SHAFT |
| UPPER | IDLE | BAR |
|
LOWER FILM |
| HEAT | SHOE |
|
|
|
|
|
| ||
Picture 1 | GUIDING | PAPER |
|
|
|
LOWER ROLL FILM
LOWER IDLE BAR
SHAFT
1.Insert the bar into the core of roll film then place the bar on the machine.
2.Place the Pressure Lever to the open mode (10~13mm).
3.Insert a piece of lightweight cardboard (Guiding Paper) between the rollers, through to beyond the second set of rollers.
**IMPORTANT : It should reach beyond the second set of rollers. It should stick out 5cm (2") in front of front roller.
4.Pull the upper film around the upper idler bar to the
5.When the temperature reaches 80°C (176°F), the resin is melting, stick the film on the shoe.
6.Allow some of the film with melted resin to stick to the Guiding Paper.
7.Repeat step 5 with lower roll film then stick it to the Guiding Paper.
8.Unwind 30~40cm(1~1.3ft) of both rolls of film, to loosen the film tension. This should be fed through to the rear roller without tension.
9.Set speed at 1 and press the "RUN" button to feed film into the machine.
10.After checking the status of lamination, Place the pressure lever at the proper lamination mode.
- 8 -