Royal Sovereign RSS-1050, RSS-1200, RSS-685 owner manual Cold Film

Page 9

2. COLD FILM

TAKE UP DEVICE

UPPER FILM SHAFT

PAPER BACK

HEAT SHOE

COLD FILM

UPPER IDLE BAR

1.Take out the guiding table.

2.Put the shaft of roll film in each hole exactly.

3.Set the pressure lever to the proper lamination mode.(1mm/5mm/10~13mm)

4.Pull the film around the idler bar to the Anti-wrinkle device.

5.Put the paper back of the film to the bobbin at take-up bar to rewind the paper back. **It is to be stuck on to roll up clock wise.

6.Place the sticky part of film on the upper shoe and get ready to laminate.

- 9 -

Image 9

Contents Royal Sovereign Laminators Table of Contents Introduction Safety PrecautionsCharacteristics SpecificationsDescription RSS-1200 RSS-1050 RSS-685 Names of Major Parts of Machine Adjustment of Film Tension and Locations HOW to Control TensionHOW to Adjust Alignment Setting UP Film HOT Film Hanging FilmCold Film Methods of controlling pressure of the roller Control of Roller PressureTerms Instructions for Control PanelLCD Window REV Stop RUN Functions of ButtonsSet the upper/ lower heat shoes HOW to USE ButtonsSpeed controls Button & DisplayUse the memorized working condition Memorize working conditionCold mode Check current temperature on the shoesCheck the laminating length & How many laminated papers HOT Laminating Laminating StepsLaminating Speed at each level Useful InformationTemp Speed Temperature/Speed adjustment guideReference Cold LaminatingTips for Remote Control and Foot Switch Method for Using CutterCross Cutter Slitters Maintenance Important Safety ConcernsIts not out of order Symptom Cause Check pointDuration of Limited Warranty Limited WarrantyMemo