Royal Sovereign RSS-1050, RSS-1200, RSS-685 owner manual Important Safety Concerns, Maintenance

Page 24

IMPORTANT SAFETY CONCERNS

1.Please be cautious that neck tie, necklace, long hair, clothes are kept well away while operation.

2.Prevent children from accessing the machine.

Extreme Heat Will Cause Injury

3.Place the machines on the plated place in order to prevent the machine from damage.

4.Make certain that the machine is connecterd to an adequate power source.

5.Do not use any other purposes other than the lamination.

MAINTENANCE

1.Do NOT Allow the machine to run with only one roll of film installed. The melted resin will adhere to one roller and ruin future laminations.

2.The width of film should be bigger than the material, and width of upper side, and lower side of film should be same in order not to allow melted resin to adhere to the rollers.

3.Be sure to adjust the film tension while in operation.

If the tension is too tight, it could cause the film to stretch.

4.After work, you should clean the resin from the rollers before beginning the next operation.

5.Please check the lubricant after long operation or you do not use for a long time.

6.Check the chain linking each gear is not loosened. The limit tension allowed is 3mm.

- 24 -

Image 24
Contents Royal Sovereign Laminators Table of Contents Safety Precautions IntroductionCharacteristics SpecificationsDescription RSS-1200 RSS-1050 RSS-685 Names of Major Parts of Machine Adjustment of Film Tension and Locations HOW to Control TensionHOW to Adjust Alignment Setting UP Film Hanging Film HOT FilmCold Film Control of Roller Pressure Methods of controlling pressure of the rollerInstructions for Control Panel TermsLCD Window Functions of Buttons REV Stop RUNHOW to USE Buttons Set the upper/ lower heat shoesSpeed controls Button & DisplayMemorize working condition Use the memorized working conditionCheck current temperature on the shoes Cold modeCheck the laminating length & How many laminated papers Laminating Steps HOT LaminatingUseful Information Laminating Speed at each levelTemperature/Speed adjustment guide Temp SpeedCold Laminating ReferenceTips for Remote Control and Foot Switch Method for Using CutterCross Cutter Slitters Important Safety Concerns MaintenanceSymptom Cause Check point Its not out of orderLimited Warranty Duration of Limited WarrantyMemo