Royal Sovereign RSS-1200, RSS-1050, RSS-685 owner manual Setting UP Film

Page 7

SETTING UP FILM

Picture 1

Picture 2

Upper Film

Picture 3

Lower Film

Picture 4

Upper Film

Picture 5

 

Core Fixing

Lower Film

Screw

1. Set the glossy side of upper/lower film to face the heat.

( Glossy side is PET film and matte side is thermal polymer laminating film.)

2.Like picture 1, insert core into the left side of upper/lower film shaft.

3.Like picture 2 and 3, insert core into the right side of upper/lower film.

4.Like picture 4 and 5, adhere core closely.

(Make the right/left direction of fixing screw consistent.)

5. Locate film in the middle, and then fasten core fixing screw.

- 7 -

Image 7
Contents Royal Sovereign Laminators Table of Contents Introduction Safety PrecautionsSpecifications CharacteristicsDescription RSS-1200 RSS-1050 RSS-685 Names of Major Parts of Machine HOW to Control Tension Adjustment of Film Tension and LocationsHOW to Adjust Alignment Setting UP Film HOT Film Hanging FilmCold Film Methods of controlling pressure of the roller Control of Roller PressureTerms Instructions for Control PanelLCD Window REV Stop RUN Functions of ButtonsButton & Display HOW to USE ButtonsSet the upper/ lower heat shoes Speed controlsUse the memorized working condition Memorize working conditionCold mode Check current temperature on the shoesCheck the laminating length & How many laminated papers HOT Laminating Laminating StepsLaminating Speed at each level Useful InformationTemp Speed Temperature/Speed adjustment guideReference Cold LaminatingMethod for Using Cutter Tips for Remote Control and Foot SwitchCross Cutter Slitters Maintenance Important Safety ConcernsIts not out of order Symptom Cause Check pointDuration of Limited Warranty Limited WarrantyMemo