Oki manual Printing on Special Media, Okijet 2500 DOS Control Panel, Envelopes

2 Printing

The OKIJET 2500 DOS Control Panel

Installing the DOS Control Panel

To install the DOS Control Panel on your computer:

1.Insert the DOS Control Panel diskette supplied with the printer in your 3-1/2" floppy disk drive.

2.At the MS-DOS prompt, type a:install (or b:\install, if b is your 3-1/2" drive) and press Enter.

The DOS Control Panel Installer menu appears, showing the factory default settings:

OKIJET2500 Printer

DOS Control Panel Installer

Install Directory	C:\OKIDATA\InkJet
Exit	Start Install

3.Make any necessary changes in the install directory.

Use the tab key to highlight the directory, press Enter, type in your new choice, and press Enter again.

4.Use the tab key to highlight Start Install, then press Enter.

The DOS Control Panel Utility will be installed in the directory you specified.

If an ERROR message appears, check the install directory specified to be sure that it is a valid path, then try again.

Loading the DOS Control Panel for Use

When you wish to use the DOS Control Panel:

1.Go to the DOS command prompt.

2.Make sure you are in the directory you specified as the Install Directory when you loaded the DOS Control Panel Utility.

3.Type OJCONPNL.

4.Press the Enter key.

Printing on Special Media

Envelopes

Envelopes should be loaded with the flap facing the front of the printer (side to be printed facing the paper tray). For best results, use short-flap,side-seam envelopes rather than v- flap envelopes:

Short-Flap Type V-Flap Type (Do not use)

18