Troubleshooting 5
5.While pressing down on the green dot inside the printer, remove the jammed paper.
6.Reinstall the Star Wheel bar:
a.Insert the pins (➊) in the cradles (➋) at either end and push the bar firmly down into place.
➊
➋
b.Pivot the bar forward and press in at either end to reengage the latch tabs.
7.Reinstall the top cover (insert pin in the hole on one side, then press against the opposite side to slip its pin into the corresponding hole).
8.Follow steps 5 through 8 under “If the Trailing Edge is Not Accessible” (see page 37).
39