PLEASE ENSURE THAT THE WING ADAPTOR (TIP ONLY) IS GENTLY, BUT MAKES A FIRM SEAL ON THE BASE OF THE INJECTOR, DO NOT push the tip into the injector as this shall split the base of the injector see Fig.16.
PLEASE ENSURE that you DOUBLE CHECK that the correct tube is located to the correct ink bottle before pulling back on the syringe (see Fig.17), you may need assistance by another person for the next stage.
Priming an Injector
Fig.16
Fig.17
At this point LOCK the tube with the white clamp (see Fig.18) before removing the syringe from the bottom base of the injector to avoid any air traveling in the injector.
Any ink remaining in the syringe can be put back into the correct ink bottle. MAKE SURE you wash the syringe with warm water ready for the next colour to be primed. Repeat this process for all the inks so that you finish up with a set of injectors and tubes full of ink as illustrated in Fig.19.
Ink tube being
clamped
Fig.18
Fig.19
9