Epson U230 manual Vertical Installation

Page 19

Confidential

TM-U230 Developer’s Guide

2.Put on the lower adapter cover with the cable through the notch in the lid and tighten the screws. In doing so, pull out the DC power supply cable from the DC power supply cable exit in the lower adapter cover so that around 15 cm of the cable protrudes from the cover.

3.Secure the covers with the screws packed with the printer (C.P.T-B Screw, 3 ⋅ 12, F/Zn).

Pull out around 15 cm
of the power cable	Screws

Lower adapter cover

notch

Power supply box assembly (2)

Vertical Installation

1.Check that the printer POWER switch is off and that the power supply cord of the AC adapter is not plugged into the wall outlet.

2.Connect DC power supply cable of the AC adapter to the DC connector on the printer.

Note:

Place the cables so that they go through the holes numbered 1 in the illlustration below. If there are many cables used, use the other holes numbered 2 (you need to break that parts).

Installation 1-11

Image 19

Contents Developer’s guide TM-U230 Confidentiality Agreement Revision Information Safety Precautions Key to SymbolsConfidential About This Guide Moduler ConnectorRelated Software and Documents Developer’s Guide Appendix a Specifications Selecting a Place of Installation Installation and Positioning of TM-U230Environment Specifications External Dimensions Dip Switch Settings Serial Interface DIP SwitchParallel Interface Ethernet Interface Changing the Location of the Rubber Feet Settings for Horizontal InstallationChanging the Orientation of Near End Sensor Attaching Switch Panel for Horizontal Installation Assembling the Power Box Vertical Installation Horizontal Installation and Wall Mounting Wall Mounting InstallationSecure the mount to the wall using all the 10 screw holes Installing the wall mountAttaching the hangers Attaching the printer to the wall Connecting a Host PCSerial interface connections Connecting to a USB interface Connecting to a parallel interfaceConnecting to an Ethernet interface Names of parts Ethernet test switchInterface cable connections Ethernet LEDsDrawer Kick-Out Connector Marked DK 22Installation Handling Important Safety InformationWaterproof Second Digit Ability to keep water out Waterproof mechanism Cutting roll paper Replacing roll paperPrinter is offline as long as the LED is flashing 6Handling Autocutter lock lever Replacing the ribbon cassette8Handling Paper jams in the vicinity of the print head Removing paper jams10Handling Be sure to properly secure the cover with the screw 11 Normal auto cutter position Paper jam in the auto cutter12 Installing the power button cover Installing the power button cover14Handling Internal Buzzer Paper roll end settings2Compatibility Receive Buffer 254, 255 Space Mounted MechanismGS V Function B Saving Space for Receipt PrintingGS V Function C Printing direction Executing a cut Assumed A/C position Assumed head position 9999999999999999 Execute GS V 98 Usage of DirectIO in Opos Contorol of The Buzzer TM-U230 41=1B284105006164050A0A Printer.font.Name = ControlA Printer.Print a Printer.EndDoc Character Specifications Printing SpecificationsAutocutter Specifications Paper SpecificationsEnvironmental Specifications Electrical SpecificationsPrinting Area Appendix A-4Specifications External Appearance Figure A-4 Without the power supply coverAppendix A-6Specifications Specifications Appendix A-7 Drawer Kick-out Specifications Drawer Kick-out ConnectorLimitations Drawer Circuitry Pin AssignmentAppendix A-10 Specifications Appendix B Comparison table AppendixC-2 AppendixC-3 AppendixC-4 AppendixC-5 AppendixC-6 Confidential Seiko Epson Corporation