Epson U230 manual Changing the Orientation of Near End Sensor

Page 16

Confidential

Changing the Orientation of Near End Sensor

Perform the following procedures to change the orientation of the near end sensor.

1.Place the printer horizontally and open the roll paper cover.

2.Use a coin to loosen the near end adjustment screw.

3.Turn the protrusion on the near end holder to change the position of the near end lever.

4.Tighten the near end adjustment screw, check that the near end sensor lever operates normally and close roll paper cover.

near end sensor holder protrusion

Roll paper cover

near end sensor adjustment screw

near end sensor lever

Changing the orientation of Near end sensor

1-8Installation

Image 16

Contents Developer’s guide TM-U230 Confidentiality Agreement Revision Information Key to Symbols Safety PrecautionsConfidential About This Guide Moduler ConnectorRelated Software and Documents Developer’s Guide Appendix a Specifications Selecting a Place of Installation Installation and Positioning of TM-U230Environment Specifications External Dimensions Dip Switch Settings DIP Switch Serial InterfaceParallel Interface Ethernet Interface Settings for Horizontal Installation Changing the Location of the Rubber FeetChanging the Orientation of Near End Sensor Attaching Switch Panel for Horizontal Installation Assembling the Power Box Vertical Installation Horizontal Installation and Wall Mounting Installation Wall MountingInstalling the wall mount Secure the mount to the wall using all the 10 screw holesAttaching the hangers Attaching the printer to the wall Connecting a Host PCSerial interface connections Connecting to a parallel interface Connecting to a USB interfaceConnecting to an Ethernet interface Ethernet test switch Names of partsEthernet LEDs Interface cable connectionsDrawer Kick-Out Connector Marked DK 22Installation Important Safety Information HandlingWaterproof Second Digit Ability to keep water out Waterproof mechanism Replacing roll paper Cutting roll paperPrinter is offline as long as the LED is flashing 6Handling Replacing the ribbon cassette Autocutter lock lever8Handling Removing paper jams Paper jams in the vicinity of the print head10Handling Be sure to properly secure the cover with the screw Paper jam in the auto cutter 11 Normal auto cutter positionInstalling the power button cover 12 Installing the power button cover14Handling Paper roll end settings Internal Buzzer2Compatibility Receive Buffer Mounted Mechanism 254, 255 SpaceSaving Space for Receipt Printing GS V Function BGS V Function C Printing direction Executing a cut Assumed A/C position Assumed head position 9999999999999999 Execute GS V 98 Usage of DirectIO in Opos Contorol of The Buzzer TM-U230 41=1B284105006164050A0A Printer.font.Name = ControlA Printer.Print a Printer.EndDoc Printing Specifications Character SpecificationsPaper Specifications Autocutter SpecificationsEnvironmental Specifications Electrical SpecificationsPrinting Area Appendix A-4Specifications Figure A-4 Without the power supply cover External AppearanceAppendix A-6Specifications Specifications Appendix A-7 Drawer Kick-out Specifications Drawer Kick-out ConnectorLimitations Pin Assignment Drawer CircuitryAppendix A-10 Specifications Appendix B Comparison table AppendixC-2 AppendixC-3 AppendixC-4 AppendixC-5 AppendixC-6 Confidential Seiko Epson Corporation