Brady 2024, 2034 manual XMFname

Char	Description			Format
k	Test RS-232 Port With a Y if OK	Sends character "Y" to RS-232 port
L	Enter label formatting mode
M	Set maximum label length	4 digits (nnnn) Max. 99.99 inch.
m	Set metric flag, enter metric mode	All measurements set to metric until
		reset
n	Clear metric flag, return to inch
	mode
O	Form edge offset (start of print	Onnnn nnnn = in/100 or mm/10
	position)
o	Cycle cutter
P	Enter character dump mode
p	Controlled pause
Q	Clear all memory modules
q	Clear module "q(A/B)"	qa a = Module ID, upper case
R	Ribbon Saver	Rx	x = (Y/N) default = Dip switch or
		front panel		(Ribbon Saver Option only)
r	Select reflective sensor	Used for "black-strip" media sensing, i.e.
		continuous tags, butt-cut labels. Stripe
		must be printed on back side of media
S	Feed rate	Sr	r = C - W, 2.0 - 12.0 ips.
s	Set for 1 dot buffer processing. Used
	for full length dot buffer processing
T	Printhead dot pattern test label
U	Label format field replacement
V	Software switch settings	Vn n = 4 -label present, 2 -Internal
		batch
			1 -Cutter enabled
v	Firmware version information	Sends version string to Host
W	Request memory module Information	Wa	a = F -font, G -graphic, L -label
w	Test FLASH module memory	Takes about 90 seconds
X	Set default module bank	Xa a = Memory Module ID, A or B
x	Delete module file	xMFname		M = A/B module ID,
				F = F,G,L file type
Y	Output sensor values	Sends sensor values status to RS-232 port
y	Symbol set select	ySaa	aa = Symbol set ID, see B-1
Z	Print internal information and dot
	pattern
z	Pack module	Za a = Memory Module ID, upper case

Table 4-3 System Level Commands (Continued)

_____________________________________________________________________________________________________

44 Printing Labels