3.Using a
4.Using the screw driver, push against the Printhead connector's guide to free the connector from its socket, then remove the Printhead.
Replacement:
5.Push the new Printhead into the connector. Align the Printhead with the alignment pins, (located on the bottom of the Printhead Mounting Plate), and secure with the Thumb Screw, (do not over tighten).
6.The Printhead must be cleaned if touched by any fingers or oils, (see Section 5.1.1).
7.Lower the Printhead, raise the Hinge Plate, and rotate the Printhead Latch until it is closed.
Figure 5-5 Printhead Removal
_____________________________________________________________________________________________________
Maintenance and Adjustments | 61 |