Brady 2024, 2034 manual Configuration Test Label, Internal Dip Switch Settings

3.3.2 Configuration Test Label

The following are explanations of the Configuration Test Label elements, top to bottom, (see Figure 3-5).

Rom Checksums − indicates whether the ROMs that store the Printer's program and resident fonts are 'good' or 'bad'. Good part numbers are displayed normally. Checksum values replace the part numbers to indicate an error. If either the ROM or RAM test is bad, service is required.

System Ram Checks − indicates 'good' or 'bad'.

System Ram Size − indicates the amount of available RAM in the Printer.

Thermal Transfer Switch − Should be 'on' if using a ribbon, and 'off ' if in the direct-thermal mode (no ribbon).

Switch 1 − indicates the status of dip switch 1 on the rear of the printer, (see Section 2.3.2, Table 2-3).

Internal − indicates the status of the Printer's internal dip switch located on the main logic board (see Table 3-1).

Paper − this value indicates when paper is present in the sensor.

Edge and Refl − indicates when media is present at the respective sensor. These sensors tell the Printer where the start of the label is located. Refer to the Programmer's Manual when determining which sensing mode to use.

Switch Functions		1	2	3	4	5	6	7
RS-422	Disabled	OFF	OFF	OFF	X	X	X	X
RS-422	Address 1	ON	OFF	OFF	X	X	X	X
RS-422	Address 2	OFF	ON	OFF	X	X	X	X
RS-422	Address 3	ON	ON	OFF	X	X	X	X
RS-422	Address 4	OFF	OFF	ON	X	X	X	X
RS-422	Address 5	ON	OFF	ON	X	X	X	X
RS-422	Address 6	OFF	ON	ON	X	X	X	X
RS-422	Address 7	ON	ON	ON	X	X	X	X
Spare		X	X	X	OFF	X	X	X
Resettable Counter Reset		X	X	X	X	OFF	X	X
Spare		X	X	X	X	X	OFF	X
RS-422 Termination (hw)		X	X	X	X	X	X	OFF

Table 3-1 Internal Dip Switch Settings

_______________________________________________________________________

36 Using Your Printer