Outback Power Systems FW-SP-250, FW-SP-ACA FW250 to check the placement of wires and components

Page 12

(5)Install the top section of the cover contain- ing the surge protector fi rst.

(6)The lower secton of the FW-SP-250 slides inside the FW250 and is then screwed into the previously installed top section. Removing the lower section allows viewing the inside of the

FW250 to check the placement of wires and components.

(7) Both sections of the FW-SP-250 are installed and secured with six Phillips screws.

(8)Route the FW-SP-250 wires through to the AC Wiring Compartment and to the battery lugs.

(9)Secure the surge protector’s wiring in the appropriate locations and replace the various plastic covers as per the wiring instructions on page 16.

11

Image 12

Contents Includes Mounting and Installation Surge ProtectorAbout OutBack Power Systems DisclaimerContact Information Warranty Introduction Dear OutBack CustomerOutback FLEXware Surge Protector ModelsIntroduction Electrical Connections and LED Indicators FLEXware Surge Protector SpecificationsLEDs MountingTools Required to Install Purpose ProcedureRemoving and installing FX M5 hex bolts Underside screw secures FW-SP-ACA to FXRemove these Two M5 hex bolts from the FX Removing various covers from the FXPreparing and installing the FW-SP-ACA onto an FX FW-SP-ACA slides onto the FXFW-SP-ACA slides down FX slots Screws included secure the FW-SP-ACA to an FXFW-SP-250 FW-SP-250FW250 to check the placement of wires and components FW-SP-R Replacement for the FW-SP-ACA or the FW-ACA ProcedureFW-ACA housing Locating pin Figures 12 FW-SP-R and FW-ACA Bracket FW-SP-R LEDsFW-SP-R installed inside the FW-ACA LED labelFW-SP-R Replacement for the FW-SP-250 Securing wires to FX DC terminalsWiring and Connecting the FLEXware Surge Protector FLEXware Surge Protector Wiring DesignationsSystem can now be powered up FLEXware Surge Protector Limited Warranty Revision Surge Protector Limited Warranty Registration Arlington, WASystem Owner 19009 62nd Avenue NE +34