Outback Power Systems manual FW-SP-R Replacement for the FW-SP-ACA or the FW-ACA, Procedure

FW-SP-R (REPLACEMENT) for the FW-SP-ACA or the FW-ACA

An FW-SP-R can replace a damaged surge protector in an FW-SP-ACA or FW-SP-250 or be installed in an FW-ACA when surge protection is desired. The FW-ACA includes a bracket for securing the

FW-SP-R.

Tools Required to Install:		Purpose:
•	Slotted screwdriver	• Wiring to the AC wiring block
•	Phillips screwdriver	• Remove and install covers
• 13 mm socket (torque ratchet)		• Securing wires to FX terminals
•	Utility knife	•	Removing plastic knockouts
• 4 mm Allen wrench		•	Removing and installing FX M5 hex bolts

NOTE: Always shut off the AC and DC power to the FX before replacing a damaged board or installing a surge protector.

(1)To install an FW-SP-R inside an FW-SP-ACA, remove the FW-SP-ACA by reversing the installation steps on pages 7-9.

Procedure

Installing an FW-SP-R inside an FW-ACA or an FW-SP-ACA

(2) Remove the FW-ACA plastic cover (secured with two Phillips screws)

(3) Remove the FW- ACA Bracket (secured with one Phillips screw); if a damaged FLEXware Surge Protector is being replaced, remove it by disengaging the locating pin

FW-ACA housing

Locating pin

Figure 11: FW-ACA

12