(5)With the FW-SP-R attached to the FW-ACA Bracket, hold the ends of the FW-SP-R wires and slide it and the bracket back inside the FW-ACA to its original location.
NOTE: The FW-SP-R slides into a double slot at the bottom of the FW-ACA. The LEDs should be level with the top of the FW-ACA housing.
(6) Secure the FW-ACA Bracket with Phillips screw
(7) If installing the FW-SP-R in an FW-ACA, place the FW-ACA plastic cover on the housing and attach the LED label to the cover, lining it up with the LEDs below.
Figure 13: FW-SP-R installed inside the FW-ACA
A
CE
TR
IR V O E R
DC
AC IN
AC OUT
LED label
(8)Install the FW-ACA onto the AC side of the FX Series Inverter/Charger (see pages 7-8) and attach the wiring (see page 16).
