Outback Power Systems FW-SP-250, FW-SP-R manual FW-SP-ACA slides down FX slots

Page 10

(10)Route the FW-SP-ACA wires through to the AC Wiring Compartment and to the battery lugs

FW-SP-ACA slides down FX slots

(11)Insert a bushing into the AC enclosure (it is not critical that this bushing line up precisely with the FW-SP-ACA); if fl exible cable is used instead of an enclosure, appropriate strain relief is required.

Screws (included) secure the FW-SP-ACA to an FX

Figure 7: Top view of FW-SP-ACA installed on an FX

(12)Secure the surge protector’s wiring in the appropriate locations and replace the various plastic covers as per the wiring instructions on page 16.

9

Image 10

Contents Includes Mounting and Installation Surge ProtectorDisclaimer About OutBack Power SystemsContact Information Warranty Introduction Dear OutBack CustomerOutback FLEXware Surge Protector ModelsIntroduction LEDs Electrical Connections and LED IndicatorsFLEXware Surge Protector Specifications MountingRemoving and installing FX M5 hex bolts Tools Required to Install PurposeProcedure Underside screw secures FW-SP-ACA to FXRemove these Two M5 hex bolts from the FX Removing various covers from the FXPreparing and installing the FW-SP-ACA onto an FX FW-SP-ACA slides onto the FXFW-SP-ACA slides down FX slots Screws included secure the FW-SP-ACA to an FXFW-SP-250 FW-SP-250FW250 to check the placement of wires and components Procedure FW-SP-R Replacement for the FW-SP-ACA or the FW-ACAFW-ACA housing Locating pin Figures 12 FW-SP-R and FW-ACA Bracket FW-SP-R LEDsFW-SP-R installed inside the FW-ACA LED labelFW-SP-R Replacement for the FW-SP-250 Securing wires to FX DC terminalsWiring and Connecting the FLEXware Surge Protector FLEXware Surge Protector Wiring DesignationsSystem can now be powered up FLEXware Surge Protector Limited Warranty Revision Arlington, WA Surge Protector Limited Warranty RegistrationSystem Owner 19009 62nd Avenue NE +34