Toshiba BSX4TGS20QMR, B-SX4T Series owner manual Covers and Panels

Page 32

4. MAINTENANCE

ENGLISH VERSION EO1-33034

4.1 Cleaning

4.1.1Print Head/Platen/ Sensors (Cont.)

NOTE:

Please purchase the Print Head Cleaner (P/No. 24089500013) from your authorised TOSHIBA TEC service representative.

4.1.2 Covers and Panels

CAUTION!

1.DO NOT POUR WATER directly onto the printer.

2.DO NOT APPLY cleaner or detergent directly onto any cover or panel.

3.NEVER USE THINNER OR OTHER VOLATILE SOLVENT on the plastic covers.

4.DO NOT clean the panel, covers, or the supply window with alcohol as it may cause them to discolour, loose their shape or develop structural weakness.

6.Clean the Print Head Element with a Print Head Cleaner or a cotton swab or soft cloth slightly moistened with alcohol.

Pinch Roller

Print Head

Print Head

Element

Platen

Feed Roller

Black Mark Sensor/

Feed Gap Sensor

7.Wipe the Platen, Feed Roller, and Pinch Roller with a soft cloth slightly moistened with alcohol. Remove dust or foreign substances from the internal part of the printer.

8.Wipe the Feed Gap Sensor and Black Mark Sensor with a dry soft cloth.

Wipe the covers and panels with a dry soft cloth or a cloth slightly moistened with mild detergent solution.

E4- 2

Image 32

Contents SX4T Series CE Compliance for EU only VorsichtWkhsoxj Precautions Request Regarding MaintenanceTable of Contents EA1-1 EA2-1EA3-1 EA4-1Unpacking Introduction FeaturesProduct Overview Accessories Dimensions AppearanceFront View Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Connecting the Cables to Your Printer GoriConnecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor positionSTANDARD/PEEL OFF position Batch modeStrip mode Build-in rewinder mode Cut modeLoading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print$5&2 Test Print Sample of the bar code test print label On Line Mode Operation PanelOperation Reset Dump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter ModuleTroubleshooting Error MessagesError Messages Problems/Causes Solutions Restart keyPossible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Removing Jammed Media Do not use any tool that may damage the Print HeadThreshold Setting Threshold setting procedureModel Appendix 1 SpecificationsA1.1 Printer A1.2 Options A1.3 MediaA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor LabelTag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area A1.4 Ribbon Figure below shows the effective print area on the mediaSymbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples Interleaved 2 CODE39 Standard JAN13, EAN13EAN13+2 digits EAN13+5 digits CODE39 Full AsciiUPC-A+5 digits Industrial 2RSS-14 RSS-14 Stacked RSS LimitedGlossaries Bar codePrint head element USB Universal Serial BusIndex Index Page EO1-33034B