Toshiba B-SX4T Series, BSX4TGS20QMR owner manual Appearance, Dimensions, Front View, Rear View

Page 9

1. PRODUCT OVERVIEW

ENGLISH VERSION EO1-33034

1.5 Appearance

1.5 Appearance

The names of the parts or units introduced in this section are used in the following chapters.

1.5.1 Dimensions

291 (11.5)

460 (18.1)

308

(12.1)

Dimensions in mm (inches)

1.5.2 Front View

LCD Message Display

Top Cover

Operation Panel

Supply Window

Media Outlet

1.5.3 Rear View

Parallel Interface

Connector (Centronics)

Serial Interface

Connector (RS-232C)

AC Power Inlet

PCMCIA Card Slot (Option), USB Connector (Option), or LAN Connector (Option)

USB Connector

(Option) or LAN

Connector (Option)

Expansion I/O Interface Connector (Option)

{Power Switch

:OFF

: ON

E1- 3

Image 9

Contents SX4T Series Vorsicht CE Compliance for EU onlyWkhsoxj Request Regarding Maintenance PrecautionsTable of Contents EA2-1 EA1-1EA3-1 EA4-1Introduction Features Product OverviewUnpacking Accessories Appearance DimensionsFront View Rear ViewInterior Operation PanelPrecautions Printer SetupProcedure before Operation Gori Connecting the Cables to Your PrinterConnecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor positionBatch mode Strip modeSTANDARD/PEEL OFF position Cut mode Build-in rewinder modeLoading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517$5&2 Test Print Sample of the bar code test print label Operation Panel On Line ModeOperation Reset Dump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Optional Cutter Module Care/Handling of the Media and RibbonError Messages TroubleshootingError Messages Problems/Causes Solutions Restart keyPossible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Do not use any tool that may damage the Print Head Removing Jammed MediaThreshold setting procedure Threshold SettingAppendix 1 Specifications A1.1 PrinterModel A1.3 Media A1.2 OptionsA1.3.1 Media Type LabelLabel A1.3.2 Detection Area of the Transmissive SensorA1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes Figure below shows the effective print area on the media A1.4 RibbonAppendix 2 Messages and Leds Symbols in the messageFollowing message appears „Interface Cables Appendix 3 InterfaceAppendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digits CODE39 Full AsciiIndustrial 2 UPC-A+5 digitsRSS-14 RSS-14 Stacked RSS LimitedBar code GlossariesUSB Universal Serial Bus Print head elementIndex Index Page EO1-33034B