Toshiba BSX4TGS20QMR, B-SX4T Series owner manual EA1-1, EA2-1, EA3-1, EA4-1

Page 6

ENGLISH VERSION EO1-33034

APPENDIX 1 SPECIFICATIONS		EA1-1
A1.1	Printer	EA1-1
A1.2	Options	EA1-2
A1.3	Media	EA1-2
	A1.3.1 Media Type	EA1-2
	A1.3.2 Detection Area of the Transmissive Sensor	EA1-3
	A1.3.3 Detection Area of the Reflective Sensor	EA1-4
	A1.3.4 Effective Print Area	EA1-4
A1.4	Ribbon	EA1-5
APPENDIX 2 MESSAGES AND LEDS		EA2-1
APPENDIX 3 INTERFACE		EA3-1
APPENDIX 4 PRINT SAMPLES		EA4-1
GLOSSARIES
INDEX

WARNING!

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CAUTION!

1.This manual may not be copied in whole or in part without prior written permission of TOSHIBA TEC.

2.The contents of this manual may be changed without notification.

3.Please refer to your local Authorised Service representative with regard to any queries you may have in this manual.

Image 6

Contents SX4T Series CE Compliance for EU only VorsichtWkhsoxj Precautions Request Regarding MaintenanceTable of Contents EA3-1 EA1-1EA2-1 EA4-1Introduction Features Product OverviewUnpacking Accessories Front View DimensionsAppearance Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Connecting the Cables to Your Printer GoriConnecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor positionBatch mode Strip modeSTANDARD/PEEL OFF position Build-in rewinder mode Cut modeLoading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print$5&2 Test Print Sample of the bar code test print label On Line Mode Operation PanelOperation Reset Dump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter ModuleError Messages Problems/Causes Solutions TroubleshootingError Messages Restart keyPossible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Removing Jammed Media Do not use any tool that may damage the Print HeadThreshold Setting Threshold setting procedureAppendix 1 Specifications A1.1 PrinterModel A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor LabelA1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes A1.4 Ribbon Figure below shows the effective print area on the mediaSymbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples EAN13+2 digits EAN13+5 digits Interleaved 2 CODE39 StandardJAN13, EAN13 CODE39 Full AsciiRSS-14 RSS-14 Stacked UPC-A+5 digitsIndustrial 2 RSS LimitedGlossaries Bar codePrint head element USB Universal Serial BusIndex Index Page EO1-33034B