Toshiba BSX4TGS20QMR, B-SX4T Series owner manual Connecting the Power Cord

Page 14

2. PRINTER SETUP

ENGLISH VERSION EO1-33034

2.5 Connecting the Power Cord

2.5Connecting the Power Cord

CAUTION!

1.Make sure that the printer Power Switch is turned to the OFF position ({) before connecting the Power Cord to prevent possible electric shock or damage to the printer.

2.Use only the Power Cord supplied with the printer. Use of any other cord may cause electric shock or fire.

3.Connect the Power Cord to a supply outlet with a properly grounded (earthed) connection.

1. Make sure that the printer Power Switch is in the OFF ( ) position.

Power Switch

2.Connect the Power Cord to the printer as shown in the figure below.

Power Cord

3.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.

Power Cord	Power Cord

[QQ Type]

[QP Type]

E2- 4

Image 14

Contents SX4T Series CE Compliance for EU only VorsichtWkhsoxj Precautions Request Regarding MaintenanceTable of Contents EA3-1 EA1-1EA2-1 EA4-1Unpacking Introduction FeaturesProduct Overview Accessories Front View DimensionsAppearance Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Connecting the Cables to Your Printer GoriConnecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor positionSTANDARD/PEEL OFF position Batch modeStrip mode Build-in rewinder mode Cut modeLoading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print$5&2 Test Print Sample of the bar code test print label On Line Mode Operation PanelOperation Reset Dump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter ModuleError Messages Problems/Causes Solutions TroubleshootingError Messages Restart keyPossible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Removing Jammed Media Do not use any tool that may damage the Print HeadThreshold Setting Threshold setting procedureModel Appendix 1 SpecificationsA1.1 Printer A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor LabelTag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area A1.4 Ribbon Figure below shows the effective print area on the mediaSymbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples EAN13+2 digits EAN13+5 digits Interleaved 2 CODE39 StandardJAN13, EAN13 CODE39 Full AsciiRSS-14 RSS-14 Stacked UPC-A+5 digitsIndustrial 2 RSS LimitedGlossaries Bar codePrint head element USB Universal Serial BusIndex Index Page EO1-33034B