Toshiba KD-1025 manual PFP board PWB

Page 23

4.2PFP board (PWB)

(1)Take off the rear cover. P.4-2 "[D] Rear cover"

(2)Disconnect 6 connectors, remove 2 screws, and release 2 locking supports to take off the PFP board.

Locking	Screws
supports
	PFP board
Fig. 4-11

4

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved	KD-1025
	DISASSEMBLY AND REPLACEMENT

4 - 5

Image 23

Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents KD-1025 SpecificationsSpecifications Front Sectional View OverviewCLT3 CLT1 M3 PWB Layout of Electrical PartsMotor Electrical PartsOverview Driving System and Feeding Operation General OperationFrom the start to the end of copying From power on to readyDescription of Operations Ready statusJam detection Error DetectionCall for Service Upper drawer feeding Flow ChartON? General Operation Drawer cover Disassembly and ReplacementInstallation and Removal of Drawers and Covers DrawersRear cover Stabilizer coverSide cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper transport roller Upper/Lower Transport RollersLower transport roller Remove the coupling, pin, and clip Bracket Upper drawer tray-up motor MotorLower drawer tray-up motor Protrusion PFP motor PFP motor assemblyRemove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Pickup roller Feed rollerDrawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Upper/lower drawer feed sensor S2/S3 Side cover open/close switch S1Drawer detection switch Upper/lower drawer detection switches S8/S9IRCUITC5. Electric Diagram5.1 HarnessCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Symbols used in the checklist Periodic MaintenanceApply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record