Toshiba KD-1025 manual Feed roller, Pickup roller

Page 34

(4)Remove the cover, the arbor, and the clutch spring from the shaft, and then take off the separation roller.

Separation roller

Clutch spring

Arbor

Shaft

Cover

Arbor

Fig. 4-42

[C]Feed roller

(1)Take off the drawer feeding unit. P.4-15 "[A] Drawer feeding unit"

(2)Take off the separation roller holder. P.4-15 "[B] Separation roller"

(3)Remove the clip and take off the feed roller.

Feed roller

Clip

Fig. 4-43

[D]Pickup roller

(1)Take off the drawer feeding unit. P.4-15 "[A] Drawer feeding unit"

(2)Raise the pickup arm and release the pickup roller assembly.

(3)Remove the belt and take off the pickup roller assembly.

Pickup roller assembly

Belt

Fig. 4-44

KD-1025

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved

DISASSEMBLY AND REPLACEMENT

 

4 - 16

Image 34
Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents Specifications KD-1025Specifications Overview Front Sectional ViewLayout of Electrical Parts CLT3 CLT1 M3 PWBElectrical Parts MotorOverview General Operation Driving System and Feeding OperationReady status From power on to readyDescription of Operations From the start to the end of copyingCall for Service Error DetectionJam detection Flow Chart Upper drawer feedingON? General Operation Drawers Disassembly and ReplacementInstallation and Removal of Drawers and Covers Drawer coverStabilizer cover Rear coverFeeding side rear cover Feeding side front coverSide cover Block PFP board PWB Upper/Lower Transport Rollers Upper transport rollerLower transport roller Remove the coupling, pin, and clip Bracket Motor Upper drawer tray-up motorLower drawer tray-up motor Protrusion PFP motor assembly PFP motorRemove 1 connector and take off the PFP motor assembly Drawer feeding unit Feed/Separation/Pickup RollerSeparation roller Feed roller Pickup rollerDrawer feed clutch CLT2/CLT3 Tray-up sensor S4/S5/paper empty sensor S6/S7 Switches and SensorsPaper stock sensor S10/S11 Side cover open/close switch S1 Upper/lower drawer feed sensor S2/S3Upper/lower drawer detection switches S8/S9 Drawer detection switchDiagram5.1 Harness IRCUITC5. ElectricCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Periodic Maintenance Symbols used in the checklistApply grease On the inside entirely Lever Separation roller Ver.02 Revision RecordVer.01 Revision Record