Toshiba KD-1025 manual Drawer feed clutch CLT2/CLT3

Page 35

(4)Remove pulley, one-way clutch, and 3 E- rings to take off the pickup roller.

Pulley

One-way clutch

Pickup roller

E-rings

Fig. 4-45

4

[E]Drawer feed clutch (CLT2/CLT3)

(1)Take off the drawer feeding unit. P.4-15 "[A] Drawer feeding unit"

(2)Remove 2 screws, and take off the clutch bracket and the bushing.

(3)Remove 1 connector and take off the clutch.

Note:

Match the protruding portion of the clutch with the position shown in the figure for assembling.

Bushing

Clutch bracket

Fig. 4-46

Protrusion

Clutch

Connector

Fig. 4-47

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved

KD-1025

 

DISASSEMBLY AND REPLACEMENT

4 - 17

Image 35
Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents KD-1025 SpecificationsSpecifications Front Sectional View OverviewCLT3 CLT1 M3 PWB Layout of Electrical PartsMotor Electrical PartsOverview Driving System and Feeding Operation General OperationFrom the start to the end of copying From power on to readyDescription of Operations Ready statusJam detection Error DetectionCall for Service Upper drawer feeding Flow ChartON? General Operation Drawer cover Disassembly and ReplacementInstallation and Removal of Drawers and Covers DrawersRear cover Stabilizer coverSide cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper transport roller Upper/Lower Transport RollersLower transport roller Remove the coupling, pin, and clip Bracket Upper drawer tray-up motor MotorLower drawer tray-up motor Protrusion PFP motor PFP motor assemblyRemove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Pickup roller Feed rollerDrawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Upper/lower drawer feed sensor S2/S3 Side cover open/close switch S1Drawer detection switch Upper/lower drawer detection switches S8/S9IRCUITC5. Electric Diagram5.1 HarnessCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Symbols used in the checklist Periodic MaintenanceApply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record