Toshiba KD-1025 manual Remove the coupling, pin, and clip

Page 26

(4)Remove 2 screws and take off the bracket of the feeding gear.

Fig. 4-18

(5)Remove 1 connector and take off the transport clutch.

Transport clutch

(6)Remove the coupling, pin, and clip.

Connector

Fig. 4-19

Coupling

Pin

Clip

Fig. 4-20

KD-1025	© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT

4 - 8

Image 26

Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents Specifications KD-1025Specifications Overview Front Sectional ViewLayout of Electrical Parts CLT3 CLT1 M3 PWBElectrical Parts MotorOverview General Operation Driving System and Feeding OperationReady status From power on to readyDescription of Operations From the start to the end of copyingJam detection Error DetectionCall for Service Flow Chart Upper drawer feedingON? General Operation Drawers Disassembly and ReplacementInstallation and Removal of Drawers and Covers Drawer coverStabilizer cover Rear coverSide cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper/Lower Transport Rollers Upper transport rollerLower transport roller Remove the coupling, pin, and clip Bracket Motor Upper drawer tray-up motorLower drawer tray-up motor Protrusion PFP motor assembly PFP motorRemove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Feed roller Pickup rollerDrawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Side cover open/close switch S1 Upper/lower drawer feed sensor S2/S3Upper/lower drawer detection switches S8/S9 Drawer detection switchDiagram5.1 Harness IRCUITC5. ElectricCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Periodic Maintenance Symbols used in the checklistApply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record