Toshiba KD-1025 manual Lower drawer tray-up motor

Page 29

[B]Lower drawer tray-up motor

(1)Take off the rear cover.

P.4-2 "[D] Rear cover"

(2)Loosen 1 screw fixing the tensioner bracket.

Fig. 4-27

(3)Remove the belt.

4

Note:

When installing the belt, be sure to confirm the gap between the belts with the following procedure.

1.Install the belt in KD-1025.

2.Tighten 1 fixing screw of the tensioner bracket.

3.Confirm that the gap between the belts is approx. 3 mm.

Fig. 4-28

Approx.3mm

Fixing screw

Fig. 4-29

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved

KD-1025

 

DISASSEMBLY AND REPLACEMENT

4 - 11

Image 29
Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents KD-1025 SpecificationsSpecifications Front Sectional View OverviewCLT3 CLT1 M3 PWB Layout of Electrical PartsMotor Electrical PartsOverview Driving System and Feeding Operation General OperationDescription of Operations From power on to readyReady status From the start to the end of copyingJam detection Error DetectionCall for Service Upper drawer feeding Flow ChartON? General Operation Installation and Removal of Drawers and Covers Disassembly and ReplacementDrawers Drawer coverRear cover Stabilizer coverSide cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper transport roller Upper/Lower Transport RollersLower transport roller Remove the coupling, pin, and clip Bracket Upper drawer tray-up motor MotorLower drawer tray-up motor Protrusion PFP motor PFP motor assemblyRemove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Pickup roller Feed rollerDrawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Upper/lower drawer feed sensor S2/S3 Side cover open/close switch S1Drawer detection switch Upper/lower drawer detection switches S8/S9IRCUITC5. Electric Diagram5.1 HarnessCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Symbols used in the checklist Periodic MaintenanceApply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record