Toshiba KD-1025 manual Revision Record, Ver.02, Ver.01

Page 47

REVISION RECORD

Ver.02

 

Ver.02 <2011.12.15>

Page

Contents

-The TOSHIBA logo on the cover page has been changed.

-The copyright description on the back side of the cover page has been changed.

5-1

The model name in "5.1 Harness Diagram" has been changed.

Ver.01

 

Ver.01 <2010.02.05>

Page

Contents

4-7

“Note” and an illustration for installing the belt have been added.

4-11

“Note” and an illustration for installing the belt have been added.

4-14

“Note” and an illustration for installing the belt have been added.

5-1

“5.1 Harness Diagram” has been corrected.

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved

KD-1025

 

REVISION RECORD

1

Image 47
Contents KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents KD-1025 SpecificationsSpecifications Front Sectional View OverviewCLT3 CLT1 M3 PWB Layout of Electrical PartsMotor Electrical PartsOverview Driving System and Feeding Operation General OperationFrom the start to the end of copying From power on to readyDescription of Operations Ready statusJam detection Error DetectionCall for Service Upper drawer feeding Flow ChartON? General Operation Drawer cover Disassembly and ReplacementInstallation and Removal of Drawers and Covers DrawersRear cover Stabilizer coverSide cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper transport roller Upper/Lower Transport RollersLower transport roller Remove the coupling, pin, and clip Bracket Upper drawer tray-up motor MotorLower drawer tray-up motor Protrusion PFP motor PFP motor assemblyRemove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Pickup roller Feed rollerDrawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Upper/lower drawer feed sensor S2/S3 Side cover open/close switch S1Drawer detection switch Upper/lower drawer detection switches S8/S9IRCUITC5. Electric Diagram5.1 HarnessCircuit Diagram Electric Circuit Equipment PC Board Electric Circuit Symbols used in the checklist Periodic MaintenanceApply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record