Toshiba KD-1025 manual Apply grease On the inside entirely Lever Separation roller

*c1. Separation roller

Apply an even coat of grease (Alvania No.2) to all round the inside of the spring. When replacing the separation roller, apply adequate amount of white grease (Molykote HP-300) on the places of the holder shown in the figure (4 places).

Separation roller Holder

Apply grease

on the inside entirely

Lever

Separation roller

Fig. 6-2 Fig. 6-3

Note:

Make sure that the grease does not adhere to the roller surface. Wipe it off with alcohol if adhered.

*c2. Drive gears in the paper feeding section (teeth of gears and shafts)

Apply some white grease (Molykote EM-30L) to the teeth of gears and shafts of the drive gears.

Note:

Make sure that oil is not running over or scattered around as the gear is rotated coming into the clutch after applying Molykote to the gear which is located near the clutch. The quantity of Molykote should be smaller than that to be applied to the other parts.

KD-1025	© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
PERIODIC MAINTENANCE

6 - 2