Toshiba B-EV4D SERIES, EO1-33088 Self Print Test and Dump Mode Cont, Printer Setup, E2-16

2. PRINTER SETUP

ENGLISH VERSION EO1-33088

2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities

2.8.2Self Print Test and Dump Mode (Cont.)

The test print contents should be changed by the following commands and parameters:

PROGRAM VERSION: VX.XX XXXX ---	Firmware version and checksum
TONE ADJUST: +XX -------------------------	Print tone fine adjustment value
FEED ADJUST: +XX.Xmm ------------------	Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm -----	Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm ----------	Back feed amount fine adjustment value
PARAMETER: [PC-850][0] -----------------	Character code selection and Font “0”
	selection
[9600][8][1][NONE][2] ---	Baud rate, Data length, Stop bit length,
	Parity, and Transmission control of RS-
	232C
[ON][AUTO][FEED][B0]-----	Forward feed wait function, Control code,
	Feed key function, and Euro code
X-COORDINTE ADJUST: +XX.Xmm -----	X-coordinate fine adjustment value
SENSOR SELECTION: TRANSMISSIVE - Sensor selection and sensitivity
SENSOR ADJ. VALUE:	Sensor setting value
TRANSMISSIVE[XX] REFLECTIVE[XX] --
PRINT SPEED: 5IPS ---------------------------	Print Speed
FLASH ROM:4MB -----------------------------	Flash ROM Capacity
SDRAM: 8MB-----------------------------------	SDRAM Capacity
USER MEMORY: [X KB][0 KB] ------------	User Memory Capacity
TTF AREA: [XXXKB][XXXKB]------------	True type font storage area, Main PC board
	and optional memory card
EXT CHAR AREA: [XXXKB][XXXKB] --	Writable character storage area, Main PC
	board and optional memory card
BASIC AREA: [XXXKB][XXXKB] --------	BASIC file storage area, Main PC board and
	optional memory card
PC SAVE AREA: [XXXKB][XXXKB] -----	PC save storage area, Main PC board and
	optional memory card
INFORMATION: -------------------------------	Printed only when some information is
	stored in the flash ROM
TOTAL FEED-----------------------------------	Total feed distance
TOTAL PRINT: 0.00 km ----------------------	Total Print distance
TOTAL CUT: 0 ---------------------------------	Total Cut Count
IP ADDRESS: 192.168.10.20 -----------------
SUBNET MASK: 255.255.255.0 -------------
GATEWAY: 0.0.0.0 ----------------------------
MAC ADDRESS: XX-XX-XX-XX-XX ----
DHCP: Disabled---------------------------------	Network setting values
DHCP CLIENT ID:

FFFFFFFFFFFFFFFFFFFF FFFFFFFFFFFF ----

SOCKET COMM.: Enabled-------------------

SOCKET COMM. PORT: 08000-------------

E2-16