Toshiba 2550c, 2551c, 2050c, 2051c Saving energy when not in use energy saving modes, From the mode

Chapter 1 PREPARATIONS

Saving energy when not in use – energy saving modes –

This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment enters into or recovers from each mode.

Energy saving	Procedure to switch	Conditions to enter into	Status of equipment	Conditions to recover
modes	modes	the mode		from the mode
Automatic	When a specified period of		“Saving energy - press	When a button on the
	time *1 has passed since the		START button.” appears on	control panel *2 is pressed
Energy Save		—
	last use of the equipment.		the touch panel.	or when print data or fax
mode
				data are received.
	When the [ENERGY SAVER]	When a particular option *5	The touch panel display	Same as the Automatic
	button *3 is pressed or	is installed or when a	goes off and the [ENERGY	Energy Save mode.
Sleep mode	when a specified period of	particular protocol *6 is	SAVER] button lights in
	time *4 has passed since the	enabled.	green.
	last use of the equipment.
	When the [ENERGY SAVER]	When a particular option *5	Only the MAIN POWER	When the [POWER] button
	button *3 is pressed or	is not installed and also	lamp (green) lights.	is pressed, when print or
Super Sleep	when a specified period of	when a particular protocol		fax data are received
mode	time *4 has passed since the	*6 is disabled.		through a wired LAN or
	last use of the equipment.			when the time set for
				Scheduled Print has come.

*1 The default value set at the factory shipment is 1 minute.

*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.

*3 [ENERGY SAVER] button on the control panel.

*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).

*5 The Wireless LAN Module and/or e-BRIDGE ID Gate.

*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO (-1000MB)] or [1000BASE FULL], the equipment enters into the Sleep mode. For details, refer to the following guide:

&TopAccess Guide (PDF): “Chapter 8: [Administration] Tab Page” - “[Setup] Item list”

For changing the set period of time for entering into each mode, refer to the following guide:

For the European version

Contact your service representative to change the default settings noted above.

&MFP Management Guide (PDF): “Chapter 2: SETTING ITEMS (ADMIN)” - “Setting General Functions”

When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.

14