Dell W07B Installing the Control Board, Removing the Wireless Local Area Network Wlan Card

Page 15

a)stand cover

b)VESA stand

c)back cover

3.Disconnect the cables from the control board and remove the screws that secure the control board to the computer. Remove the control board from the computer.

Installing the Control Board

1.Place the control board on the computer.

2.Tighten the screws to secure the control board to the computer.

3.Connect the cables to the control board.

4.Install:

a)back cover

b)VESA stand

c)stand cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the Wireless Local Area Network (WLAN) Card

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

d)system board cover

3.Disconnect the antenna cables from the WLAN card. Remove the screw that secures the WLAN card to the system board. Lift and remove the WLAN card from the computer.

15

Image 15

Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Technical Specifications Contacting Dell System SetupDiagnostics Troubleshooting Your ComputerBefore Working Inside Your Computer Working on Your ComputerRecommended Tools Turning Off Your ComputerClick Shut Down Important Information After Working Inside Your ComputerPage System Overview Removing and Installing ComponentsInstalling the Stand Cover Removing the Stand CoverRemoving the Vesa Stand Removing the Back Cover Installing the Vesa StandRemove the back cover from the computer Removing the Optical Disk Drive Installing the Back CoverInstalling the Optical Disk Drive Removing the Control BoardRemove Removing the Wireless Local Area Network Wlan Card Installing the Control BoardRemoving the Memory Installing the Wlan CardRemoving the System Board Cover Installing the MemoryRemoving the Coin-Cell Battery Installing the System Board CoverRemoving the Heat Sink Installing the Coin-Cell BatteryInstalling the Heat Sink Installing the System FanRemoving the System Fan Installing the Processor Removing the Intrusion SwitchRemoving the Processor Removing the Speakers Installing the Intrusion SwitchRemoving the Power Switch Installing the SpeakersRemoving the Hard Drive Installing the Power SwitchPage Removing the System Board Installing the Hard DrivePage Page Page System Board Components Serial port connectorRemoving the Display Bracket Installing the System BoardPage Page Installing the Display Bracket Installing the Camera Removing the CameraVesa stand Stand cover Removing the Serial Port Installing the Serial Port Page Navigation Keys System SetupBoot Sequence Following table displays the system setup navigation keysSystem Setup Options Date/Time Advanced Boot OptionsExit Exits and starts the computer Not selected. The other options areEnable Audio option is selected Reporting Technology specificationEnable Smart Reporting This option is disabled by default USB ConfigurationInternal HDD-0 Password With a system password and/or HDD passwordSystem Password Primary passwordEnabled DisabledEnabled by default Keys will restore to default settingsAll Enabled by default Option is enabled by defaultOptionDescription Bluetooth 255.255.255.255 Verbose ModeComputer Updating the BiosSystem and Setup Password Re-start the computerPress Y to save the changes. The computer reboots Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Important Information Diagnostic Power LED Codes Troubleshooting Your ComputerBeep Codes Error MessagesMessage Page Feature Specification Technical SpecificationsFeature SpecificationControl keys Mini PCI Express OneAdapter bracket Ports and Connectors Reading data from or writing data to the hard drive Feature Specification Non-TouchTilt Degrees to 30 degrees Kg 8.63 kg 17.94 lb 19.02 lbBack of the computer and the electrical outlet Power supply diagnostic lightPage Contacting Dell