Dell W07B owner manual Installing the Intrusion Switch, Removing the Speakers

Page 22

Installing the Intrusion Switch

1.Place the intrusion switch on the computer.

2.Guide the intrusion-switch cables through the tabs on the computer and connect the cable to the system board.

3.Install:

a)system fan

b)system board cover

c)back cover

d)VESA stand

e)stand cover

4.Follow the procedures in After Working Inside Your Computer.

Removing the Speakers

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

d)system board cover

3.Disconnect the speaker cable from the system board. Remove the screws that secure the speakers to the computer and remove the speakers from the computer.

22

Image 22
Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Troubleshooting Your Computer System SetupDiagnostics Technical Specifications Contacting DellWorking on Your Computer Before Working Inside Your ComputerTurning Off Your Computer Recommended ToolsClick Shut Down After Working Inside Your Computer Important InformationPage Removing and Installing Components System OverviewRemoving the Stand Cover Installing the Stand CoverRemoving the Vesa Stand Installing the Vesa Stand Removing the Back CoverRemove the back cover from the computer Installing the Back Cover Removing the Optical Disk DriveRemoving the Control Board Installing the Optical Disk DriveRemove Installing the Control Board Removing the Wireless Local Area Network Wlan CardInstalling the Wlan Card Removing the MemoryInstalling the Memory Removing the System Board CoverInstalling the System Board Cover Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the Heat SinkInstalling the System Fan Installing the Heat SinkRemoving the System Fan Removing the Intrusion Switch Installing the ProcessorRemoving the Processor Installing the Intrusion Switch Removing the SpeakersInstalling the Speakers Removing the Power SwitchInstalling the Power Switch Removing the Hard DrivePage Installing the Hard Drive Removing the System BoardPage Page Page Serial port connector System Board ComponentsInstalling the System Board Removing the Display BracketPage Page Installing the Display Bracket Removing the Camera Installing the CameraVesa stand Stand cover Removing the Serial Port Installing the Serial Port Page Following table displays the system setup navigation keys System SetupBoot Sequence Navigation KeysSystem Setup Options Not selected. The other options are Advanced Boot OptionsExit Exits and starts the computer Date/TimeUSB Configuration Reporting Technology specificationEnable Smart Reporting This option is disabled by default Enable Audio option is selectedPrimary password With a system password and/or HDD passwordSystem Password Internal HDD-0 PasswordDisabled EnabledOption is enabled by default Keys will restore to default settingsAll Enabled by default Enabled by defaultOptionDescription Bluetooth Verbose Mode 255.255.255.255Re-start the computer Updating the BiosSystem and Setup Password ComputerPress Y to save the changes. The computer reboots Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Important Information Diagnostic Power LED CodesError Messages Beep CodesMessage Page Specification Technical SpecificationsFeature Feature SpecificationMini PCI Express One Control keysAdapter bracket Ports and Connectors Kg 8.63 kg 17.94 lb 19.02 lb Feature Specification Non-TouchTilt Degrees to 30 degrees Reading data from or writing data to the hard drivePower supply diagnostic light Back of the computer and the electrical outletPage Contacting Dell