Dell W07B owner manual Installing the System Board, Removing the Display Bracket

Page 31

Installing the System Board

1.Place the system board on the computer.

2.Tighten the screws to secure the system board to the base panel.

3.Connect all the cables to the system board.

4.Install:

a)optical disk drive

b)hard drive

c)heat sink

d)WLAN card

e)memory

f)system board cover

g)back cover

h)VESA stand

i)stand cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the Display Bracket

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

d)system board cover

e)WLAN card

f)memory

g)heat sink

h)hard drive

i)optical disk drive

j)control board

k)system fan

l)intrusion switch

m)power switch

n)system board

3.Release the camera cable and the display cable from their tabs on the display bracket.

31

Image 31

Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Technical Specifications Contacting Dell System SetupDiagnostics Troubleshooting Your ComputerBefore Working Inside Your Computer Working on Your ComputerTurning Off Your Computer Recommended ToolsClick Shut Down Important Information After Working Inside Your ComputerPage System Overview Removing and Installing ComponentsRemoving the Stand Cover Installing the Stand CoverRemoving the Vesa Stand Removing the Back Cover Installing the Vesa StandRemove the back cover from the computer Removing the Optical Disk Drive Installing the Back CoverRemoving the Control Board Installing the Optical Disk DriveRemove Removing the Wireless Local Area Network Wlan Card Installing the Control BoardRemoving the Memory Installing the Wlan CardRemoving the System Board Cover Installing the MemoryRemoving the Coin-Cell Battery Installing the System Board CoverRemoving the Heat Sink Installing the Coin-Cell BatteryInstalling the System Fan Installing the Heat SinkRemoving the System Fan Removing the Intrusion Switch Installing the ProcessorRemoving the Processor Removing the Speakers Installing the Intrusion SwitchRemoving the Power Switch Installing the SpeakersRemoving the Hard Drive Installing the Power SwitchPage Removing the System Board Installing the Hard DrivePage Page Page System Board Components Serial port connectorRemoving the Display Bracket Installing the System BoardPage Page Installing the Display Bracket Removing the Camera Installing the CameraVesa stand Stand cover Removing the Serial Port Installing the Serial Port Page Navigation Keys System SetupBoot Sequence Following table displays the system setup navigation keysSystem Setup Options Date/Time Advanced Boot OptionsExit Exits and starts the computer Not selected. The other options areEnable Audio option is selected Reporting Technology specificationEnable Smart Reporting This option is disabled by default USB ConfigurationInternal HDD-0 Password With a system password and/or HDD passwordSystem Password Primary passwordEnabled DisabledEnabled by default Keys will restore to default settingsAll Enabled by default Option is enabled by defaultOptionDescription Bluetooth 255.255.255.255 Verbose ModeComputer Updating the BiosSystem and Setup Password Re-start the computerPress Y to save the changes. The computer reboots Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Important Information Diagnostic Power LED Codes Troubleshooting Your ComputerBeep Codes Error MessagesMessage Page Feature Specification Technical SpecificationsFeature SpecificationMini PCI Express One Control keysAdapter bracket Ports and Connectors Reading data from or writing data to the hard drive Feature Specification Non-TouchTilt Degrees to 30 degrees Kg 8.63 kg 17.94 lb 19.02 lbBack of the computer and the electrical outlet Power supply diagnostic lightPage Contacting Dell