Dell W07B Removing the Stand Cover, Installing the Stand Cover, Removing the Vesa Stand

Page 10

6.memory

7.system board

8.coin-cell battery

9.speaker

10.WLAN card slot

11.hard drive

12.communication port

13.power switch

14.chassis

Removing the Stand Cover

1.Follow the procedures in Before Working Inside Your Computer.

2.Place the computer on a flat surface, display side facing downwards.

3.Press the tab in to release the stand cover and remove it from the computer.

Installing the Stand Cover

1.Slide the stand cover into its place and press to secure it to the computer.

2.Follow the procedures in After Working Inside Your Computer.

Removing the VESA Stand

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the stand cover.

3.Remove the screws that secure the VESA stand to the computer and remove the VESA stand from the computer.

10

Image 10

Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Troubleshooting Your Computer System SetupDiagnostics Technical Specifications Contacting DellWorking on Your Computer Before Working Inside Your ComputerTurning Off Your Computer Recommended ToolsClick Shut Down After Working Inside Your Computer Important InformationPage Removing and Installing Components System OverviewRemoving the Stand Cover Installing the Stand CoverRemoving the Vesa Stand Installing the Vesa Stand Removing the Back CoverRemove the back cover from the computer Installing the Back Cover Removing the Optical Disk DriveRemoving the Control Board Installing the Optical Disk DriveRemove Installing the Control Board Removing the Wireless Local Area Network Wlan CardInstalling the Wlan Card Removing the MemoryInstalling the Memory Removing the System Board CoverInstalling the System Board Cover Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the Heat SinkInstalling the System Fan Installing the Heat SinkRemoving the System Fan Removing the Intrusion Switch Installing the ProcessorRemoving the Processor Installing the Intrusion Switch Removing the SpeakersInstalling the Speakers Removing the Power SwitchInstalling the Power Switch Removing the Hard DrivePage Installing the Hard Drive Removing the System BoardPage Page Page Serial port connector System Board ComponentsInstalling the System Board Removing the Display BracketPage Page Installing the Display Bracket Removing the Camera Installing the CameraVesa stand Stand cover Removing the Serial Port Installing the Serial Port Page Following table displays the system setup navigation keys System SetupBoot Sequence Navigation KeysSystem Setup Options Not selected. The other options are Advanced Boot OptionsExit Exits and starts the computer Date/TimeUSB Configuration Reporting Technology specificationEnable Smart Reporting This option is disabled by default Enable Audio option is selectedPrimary password With a system password and/or HDD passwordSystem Password Internal HDD-0 PasswordDisabled EnabledOption is enabled by default Keys will restore to default settingsAll Enabled by default Enabled by defaultOptionDescription Bluetooth Verbose Mode 255.255.255.255Re-start the computer Updating the BiosSystem and Setup Password ComputerPress Y to save the changes. The computer reboots Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Important Information Diagnostic Power LED CodesError Messages Beep CodesMessage Page Specification Technical SpecificationsFeature Feature SpecificationMini PCI Express One Control keysAdapter bracket Ports and Connectors Kg 8.63 kg 17.94 lb 19.02 lb Feature Specification Non-TouchTilt Degrees to 30 degrees Reading data from or writing data to the hard drivePower supply diagnostic light Back of the computer and the electrical outletPage Contacting Dell