Dell W07B owner manual Installing the Hard Drive, Removing the System Board

Page 26

Installing the Hard Drive

1.Place the hard drive in the bracket and tighten the screws to secure the hard drive to the bracket.

2.Connect the hard-drive cable to the hard drive and place the hard drive into its slot on the computer.

3.Tighten the screws to secure the hard-drive bracket to the computer.

4.Install:

a)back cover

b)VESA stand

c)stand cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the System Board

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

d)system board cover

e)memory

f)WLAN card

g)heat sink

h)hard drive

i)optical disk drive

3.Disconnect all the cables connected to the system board.

26

Image 26

Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Troubleshooting Your Computer System SetupDiagnostics Technical Specifications Contacting DellWorking on Your Computer Before Working Inside Your ComputerClick Shut Down Recommended ToolsTurning Off Your Computer After Working Inside Your Computer Important InformationPage Removing and Installing Components System OverviewRemoving the Vesa Stand Installing the Stand CoverRemoving the Stand Cover Installing the Vesa Stand Removing the Back CoverRemove the back cover from the computer Installing the Back Cover Removing the Optical Disk DriveRemove Installing the Optical Disk DriveRemoving the Control Board Installing the Control Board Removing the Wireless Local Area Network Wlan CardInstalling the Wlan Card Removing the MemoryInstalling the Memory Removing the System Board CoverInstalling the System Board Cover Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the Heat SinkRemoving the System Fan Installing the Heat SinkInstalling the System Fan Removing the Processor Installing the ProcessorRemoving the Intrusion Switch Installing the Intrusion Switch Removing the SpeakersInstalling the Speakers Removing the Power SwitchInstalling the Power Switch Removing the Hard DrivePage Installing the Hard Drive Removing the System BoardPage Page Page Serial port connector System Board ComponentsInstalling the System Board Removing the Display BracketPage Page Installing the Display Bracket Vesa stand Stand cover Installing the CameraRemoving the Camera Removing the Serial Port Installing the Serial Port Page Following table displays the system setup navigation keys System SetupBoot Sequence Navigation KeysSystem Setup Options Not selected. The other options are Advanced Boot OptionsExit Exits and starts the computer Date/TimeUSB Configuration Reporting Technology specificationEnable Smart Reporting This option is disabled by default Enable Audio option is selectedPrimary password With a system password and/or HDD passwordSystem Password Internal HDD-0 PasswordDisabled EnabledOption is enabled by default Keys will restore to default settingsAll Enabled by default Enabled by defaultOptionDescription Bluetooth Verbose Mode 255.255.255.255Re-start the computer Updating the BiosSystem and Setup Password ComputerPress Y to save the changes. The computer reboots Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Important Information Diagnostic Power LED CodesError Messages Beep CodesMessage Page Specification Technical SpecificationsFeature Feature SpecificationAdapter bracket Control keysMini PCI Express One Ports and Connectors Kg 8.63 kg 17.94 lb 19.02 lb Feature Specification Non-TouchTilt Degrees to 30 degrees Reading data from or writing data to the hard drivePower supply diagnostic light Back of the computer and the electrical outletPage Contacting Dell