Dell W07B owner manual Installing the Serial Port

Page 37

Installing the Serial Port

1.Tighten the screws to secure the serial port to the computer.

2.Guide the serial-port cable through its tabs on the computer and connect it to the system board.

3.Install:

a)system board cover

b)back cover

c)VESA stand

d)stand cover

4.Follow the procedures in After Working Inside Your Computer.

37

Image 37

Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerTurning Off Your Computer Recommended ToolsClick Shut Down Important Information After Working Inside Your ComputerPage System Overview Removing and Installing ComponentsRemoving the Stand Cover Installing the Stand CoverRemoving the Vesa Stand Removing the Back Cover Installing the Vesa StandRemove the back cover from the computer Removing the Optical Disk Drive Installing the Back CoverRemoving the Control Board Installing the Optical Disk DriveRemove Removing the Wireless Local Area Network Wlan Card Installing the Control BoardRemoving the Memory Installing the Wlan CardRemoving the System Board Cover Installing the MemoryRemoving the Coin-Cell Battery Installing the System Board CoverRemoving the Heat Sink Installing the Coin-Cell BatteryInstalling the System Fan Installing the Heat SinkRemoving the System Fan Removing the Intrusion Switch Installing the ProcessorRemoving the Processor Removing the Speakers Installing the Intrusion SwitchRemoving the Power Switch Installing the SpeakersRemoving the Hard Drive Installing the Power SwitchPage Removing the System Board Installing the Hard DrivePage Page Page System Board Components Serial port connectorRemoving the Display Bracket Installing the System BoardPage Page Installing the Display Bracket Removing the Camera Installing the CameraVesa stand Stand cover Removing the Serial Port Installing the Serial Port Page Boot Sequence System SetupFollowing table displays the system setup navigation keys Navigation KeysSystem Setup Options Exit Exits and starts the computer Advanced Boot OptionsNot selected. The other options are Date/TimeEnable Smart Reporting This option is disabled by default Reporting Technology specificationUSB Configuration Enable Audio option is selectedSystem Password With a system password and/or HDD passwordPrimary password Internal HDD-0 PasswordEnabled DisabledAll Enabled by default Keys will restore to default settingsOption is enabled by default Enabled by defaultOptionDescription Bluetooth 255.255.255.255 Verbose ModeSystem and Setup Password Updating the BiosRe-start the computer ComputerPress Y to save the changes. The computer reboots Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Important Information Diagnostic Power LED Codes Troubleshooting Your ComputerBeep Codes Error MessagesMessage Page Feature Technical SpecificationsSpecification Feature SpecificationMini PCI Express One Control keysAdapter bracket Ports and Connectors Tilt Degrees to 30 degrees Feature Specification Non-TouchKg 8.63 kg 17.94 lb 19.02 lb Reading data from or writing data to the hard driveBack of the computer and the electrical outlet Power supply diagnostic lightPage Contacting Dell