Dell W07B owner manual Installing the Memory, Removing the System Board Cover

Page 17

Installing the Memory

1.Align the notch on the memory-card with the tab in the system-board connector.

2.Press down on the memory module until the release tabs spring back to secure them in place.

3.Place the memory cover back into its place and tighten the screw to secure it.

4.Install:

a)back cover

b)VESA stand

c)stand cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the System Board Cover

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

3.Remove the screw that secures the system board cover to the computer.

4.Lift the system board cover up to remove it from the computer.

17

Image 17
Contents Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerClick Shut Down Recommended ToolsTurning Off Your Computer Important Information After Working Inside Your ComputerPage System Overview Removing and Installing ComponentsRemoving the Vesa Stand Installing the Stand CoverRemoving the Stand Cover Removing the Back Cover Installing the Vesa StandRemove the back cover from the computer Removing the Optical Disk Drive Installing the Back CoverRemove Installing the Optical Disk DriveRemoving the Control Board Removing the Wireless Local Area Network Wlan Card Installing the Control BoardRemoving the Memory Installing the Wlan CardRemoving the System Board Cover Installing the MemoryRemoving the Coin-Cell Battery Installing the System Board CoverRemoving the Heat Sink Installing the Coin-Cell BatteryRemoving the System Fan Installing the Heat SinkInstalling the System Fan Removing the Processor Installing the ProcessorRemoving the Intrusion Switch Removing the Speakers Installing the Intrusion SwitchRemoving the Power Switch Installing the SpeakersRemoving the Hard Drive Installing the Power SwitchPage Removing the System Board Installing the Hard DrivePage Page Page System Board Components Serial port connectorRemoving the Display Bracket Installing the System BoardPage Page Installing the Display Bracket Vesa stand Stand cover Installing the CameraRemoving the Camera Removing the Serial Port Installing the Serial Port Page Boot Sequence System SetupFollowing table displays the system setup navigation keys Navigation KeysSystem Setup Options Exit Exits and starts the computer Advanced Boot OptionsNot selected. The other options are Date/TimeEnable Smart Reporting This option is disabled by default Reporting Technology specificationUSB Configuration Enable Audio option is selectedSystem Password With a system password and/or HDD passwordPrimary password Internal HDD-0 PasswordEnabled DisabledAll Enabled by default Keys will restore to default settingsOption is enabled by default Enabled by defaultOptionDescription Bluetooth 255.255.255.255 Verbose ModeSystem and Setup Password Updating the BiosRe-start the computer ComputerPress Y to save the changes. The computer reboots Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Important Information Diagnostic Power LED Codes Troubleshooting Your ComputerBeep Codes Error MessagesMessage Page Feature Technical SpecificationsSpecification Feature SpecificationAdapter bracket Control keysMini PCI Express One Ports and Connectors Tilt Degrees to 30 degrees Feature Specification Non-TouchKg 8.63 kg 17.94 lb 19.02 lb Reading data from or writing data to the hard driveBack of the computer and the electrical outlet Power supply diagnostic lightPage Contacting Dell