Dell 7010 owner manual

Page 19

3.Disconnect the fan cable from the system board.

4.Release the cable from the restraint.

5.Pry and remove the system fan away from the grommets securing it to the computer. Then, press the grommets inward along the slots and pass through the chassis.

Image 19

Contents Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents Specifications Contacting Dell System SetupDiagnostics Troubleshooting Your ComputerBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerClick Shut Down Removing the Cover Removing and Installing ComponentsInstalling the Cover Recommended ToolsRemoving the Front Bezel Installing the Front BezelInstalling The Wlan Card Removing The Wireless Local Area Network Wlan CardRemoving the Drive Cage Removing the Optical Drive Installing the Drive CagePage Removing the Hard Drive Installing the Optical DrivePry the sides of the bracket to remove the optical drive Installing the Hard Drive Removing the Intrusion Switch Memory Module Guidelines Installing the Intrusion Switch Removing the Memory Removing the Coin-Cell Battery Installing the MemoryRemoving the System Fan Installing the Coin-Cell BatteryRemove Cover Front bezel Drive cage Page Removing the Speaker Installing the System FanRemoving the Power-Switch Cable Installing the SpeakerRemoving the Input/Output I/O Panel Installing the Power-Switch CableRemoving the Power Supply Installing the Input/Output I/O PanelRemove Cover Page Page Lift the power supply out of the computer Installing the Power SupplyRemoving the Heat Sink Page Removing the Processor Installing the Heat SinkRemoving the System Board Installing the ProcessorPage System Board Components Power connectorProcessor Installing the System Board Page Navigation Keys System SetupBoot Sequence Following table displays the system setup navigation keysSystem Setup Options RAID on Sata is configured to support RAID mode Disabled The Sata controllers are hiddenATA Sata is configured for ATA mode Ahci Sata is configured for Ahci modeOptionDescription Is enabled and visible to the operating system They are set. This option is disabled by defaultPassword Change Permitted when an administrator password is setOption is enabled by default Reset All Keys- Resets to default settingKeys will restore to default settings All Enabled by defaultPower Off default Disabled by defaultAC Recovery Power loss. You can set the AC Recovery toSequence required to enter the Bios Boot Option Menu Signals. For Ultra Small Form Factor onlyIs enabled by default Keyboard ErrorsImageServer IP Software communicates. The default IP address isCommunicate. The default IP port is Serr MessagesClick Drivers & Downloads Updating the BiosJumper Settings System and Setup PasswordComputer Assigning a System Password and Setup PasswordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Possible system board resource and/or hardware failure Troubleshooting Your ComputerPower LED Diagnostics Amber LED State White LED State DescriptionBeep Code Error MessagesInformation-please Run Setup program Invalid Memory Error Message DescriptionFailure Configuration ProblemValue Memory size Disk errorNot a boot diskette System installed on it. Insert a bootable floppy diskWrite fault on Write faultSelected drive Page Feature Specification SpecificationsFeature SpecificationDiscrete PCI Express x16 graphics adapter Express Chipset CPU-GPU ComboIntegrated Two Channel High Definition Audio Back Panel Audio Front PanelForm factor Mini-Tower and Desktop One 36-pin connectorPCI Express x1 data width maximum one PCI Express lane Front of the computer Power button light ConnectorWhite light indicates sleep state of the computer Physical Height Width Depth Weight Power Wattage Maximum Heat Dissipation Voltage24.00 cm 30 kg 7.28 lb Inches Physical Height Width Depth Weight Ultra Small Form FactorPage Contacting Dell

Related manuals

Manual 47 pages 49.28 Kb