Dell 7010 owner manual Connector, Front of the computer Power button light

Page 59

Feature	Specification

Mini-Tower	four 7-pin connectors
Desktop	three 7-pin connectors
Small Form Factor	three 7-pin connectors
Ultra Small Form Factor	two 7-pin connectors
Memory:
Mini-Tower, Desktop, Small Form Factor	four 240-pin connectors
Ultra Small Form Factor	two 240-pin connectors
Internal USB:
Mini-Tower and Desktop	one 10-pin connector
Small Form Factor and Ultra Small Form Factor	none
System Fan	one 5-pin connector
Front panel control:
Mini-Tower, Desktop, Small Form Factor	one 6–pin and two 20–pin connector
Ultra Small Form Factor	one 14–pin, one 20–pin and one 10–pin
	connector
Thermal Sensor	one 2-pin connector
Processor	one 1155-pin connector
Processor Fan	one 5-pin connector
Service mode jumper	one 2-pin connector
Password clear jumper	one 2-pin connector
RTC reset jumper	one 2-pin connector
Internal speaker	one 5-pin connector
Intruder connector	one 3-pin connector
Power connector:
Mini-Tower, Desktop, Small Form Factor	one 24-pin and one 4-pin connector
Ultra Small Form Factor	one 8-pin, one 6-pin, and one 4-pin
	connector
Table 26. Controls and Lights

Feature	Specification

Front of the computer:
Power button light	White light — Solid white light indicates power-on state; blinking
	white light indicates sleep state of the computer.

59

Image 59

Contents Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents Specifications Contacting Dell System SetupDiagnostics Troubleshooting Your ComputerBefore Working Inside Your Computer Working on Your ComputerClick Shut Down Turning Off Your ComputerAfter Working Inside Your Computer Removing the Cover Removing and Installing ComponentsInstalling the Cover Recommended ToolsRemoving the Front Bezel Installing the Front BezelInstalling The Wlan Card Removing The Wireless Local Area Network Wlan CardRemoving the Drive Cage Removing the Optical Drive Installing the Drive CagePage Pry the sides of the bracket to remove the optical drive Installing the Optical DriveRemoving the Hard Drive Installing the Hard Drive Removing the Intrusion Switch Removing the Memory Installing the Intrusion SwitchMemory Module Guidelines Removing the Coin-Cell Battery Installing the MemoryRemove Cover Front bezel Drive cage Installing the Coin-Cell BatteryRemoving the System Fan Page Removing the Speaker Installing the System FanRemoving the Power-Switch Cable Installing the SpeakerRemoving the Input/Output I/O Panel Installing the Power-Switch CableRemove Cover Installing the Input/Output I/O PanelRemoving the Power Supply Page Page Lift the power supply out of the computer Installing the Power SupplyRemoving the Heat Sink Page Removing the Processor Installing the Heat SinkRemoving the System Board Installing the ProcessorPage Processor Power connectorSystem Board Components Installing the System Board Page Navigation Keys System SetupBoot Sequence Following table displays the system setup navigation keysSystem Setup Options RAID on Sata is configured to support RAID mode Disabled The Sata controllers are hiddenATA Sata is configured for ATA mode Ahci Sata is configured for Ahci modeOptionDescription Is enabled and visible to the operating system They are set. This option is disabled by defaultPassword Change Permitted when an administrator password is setOption is enabled by default Reset All Keys- Resets to default settingKeys will restore to default settings All Enabled by defaultPower Off default Disabled by defaultAC Recovery Power loss. You can set the AC Recovery toSequence required to enter the Bios Boot Option Menu Signals. For Ultra Small Form Factor onlyIs enabled by default Keyboard ErrorsImageServer IP Software communicates. The default IP address isCommunicate. The default IP port is Serr MessagesClick Drivers & Downloads Updating the BiosJumper Settings System and Setup PasswordComputer Assigning a System Password and Setup PasswordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Possible system board resource and/or hardware failure Troubleshooting Your ComputerPower LED Diagnostics Amber LED State White LED State DescriptionBeep Code Error MessagesInformation-please Run Setup program Invalid Memory Error Message DescriptionFailure Configuration ProblemValue Memory size Disk errorNot a boot diskette System installed on it. Insert a bootable floppy diskSelected drive Write faultWrite fault on Page Feature Specification SpecificationsFeature SpecificationIntegrated Two Channel High Definition Audio Express Chipset CPU-GPU ComboDiscrete PCI Express x16 graphics adapter Back Panel Audio Front PanelPCI Express x1 data width maximum one PCI Express lane Mini-Tower and Desktop One 36-pin connectorForm factor White light indicates sleep state of the computer ConnectorFront of the computer Power button light Physical Height Width Depth Weight Power Wattage Maximum Heat Dissipation Voltage24.00 cm 30 kg 7.28 lb Inches Physical Height Width Depth Weight Ultra Small Form FactorPage Contacting Dell

Related manuals

Manual 47 pages 49.28 Kb