Dell 7010 owner manual

Page 24

b)front bezel

c)drive cage

3.Disconnect the 4-pin power cable from the system board and un-thread the cable from the chassis clips.

4.Remove the power cable from the restraint.

24

Image 24

Contents Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents System Setup DiagnosticsTroubleshooting Your Computer Specifications Contacting DellWorking on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your ComputerClick Shut Down Removing and Installing Components Installing the CoverRecommended Tools Removing the CoverInstalling the Front Bezel Removing the Front BezelRemoving The Wireless Local Area Network Wlan Card Installing The Wlan CardRemoving the Drive Cage Installing the Drive Cage Removing the Optical DrivePage Installing the Optical Drive Removing the Hard DrivePry the sides of the bracket to remove the optical drive Installing the Hard Drive Removing the Intrusion Switch Installing the Intrusion Switch Memory Module GuidelinesRemoving the Memory Installing the Memory Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the System FanRemove Cover Front bezel Drive cage Page Installing the System Fan Removing the SpeakerInstalling the Speaker Removing the Power-Switch CableInstalling the Power-Switch Cable Removing the Input/Output I/O PanelInstalling the Input/Output I/O Panel Removing the Power SupplyRemove Cover Page Page Installing the Power Supply Lift the power supply out of the computerRemoving the Heat Sink Page Installing the Heat Sink Removing the ProcessorInstalling the Processor Removing the System BoardPage Power connector System Board ComponentsProcessor Installing the System Board Page System Setup Boot SequenceFollowing table displays the system setup navigation keys Navigation KeysSystem Setup Options Disabled The Sata controllers are hidden ATA Sata is configured for ATA modeAhci Sata is configured for Ahci mode RAID on Sata is configured to support RAID modeOptionDescription They are set. This option is disabled by default Password ChangePermitted when an administrator password is set Is enabled and visible to the operating systemReset All Keys- Resets to default setting Keys will restore to default settingsAll Enabled by default Option is enabled by defaultDisabled by default AC RecoveryPower loss. You can set the AC Recovery to Power Off defaultSignals. For Ultra Small Form Factor only Is enabled by defaultKeyboard Errors Sequence required to enter the Bios Boot Option MenuSoftware communicates. The default IP address is Communicate. The default IP port isSerr Messages ImageServer IPUpdating the Bios Jumper SettingsSystem and Setup Password Click Drivers & DownloadsAssigning a System Password and Setup Password ComputerDisabling a System Password Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Power LED DiagnosticsAmber LED State White LED State Description Possible system board resource and/or hardware failureError Messages Beep CodeError Message Description Failure ConfigurationProblem Information-please Run Setup program Invalid MemoryDisk error Not a boot disketteSystem installed on it. Insert a bootable floppy disk Value Memory sizeWrite fault Write fault onSelected drive Page Specifications FeatureSpecification Feature SpecificationExpress Chipset CPU-GPU Combo Discrete PCI Express x16 graphics adapterIntegrated Two Channel High Definition Audio Audio Front Panel Back PanelMini-Tower and Desktop One 36-pin connector Form factorPCI Express x1 data width maximum one PCI Express lane Connector Front of the computer Power button lightWhite light indicates sleep state of the computer Power Wattage Maximum Heat Dissipation Voltage Physical Height Width Depth WeightPhysical Height Width Depth Weight Ultra Small Form Factor 24.00 cm 30 kg 7.28 lb InchesPage Contacting Dell

Related manuals

Manual 47 pages 49.28 Kb