Dell 7010 owner manual Installing the Optical Drive, Removing the Hard Drive

Page 13

5.Pry the sides of the bracket to remove the optical drive.

Installing the Optical Drive

1.Insert the optical drive into the bracket.

2.Lift the blue tab and slide the optical drive outwards to insert it into the computer.

3.Connect the data cable and power cable to the optical drive.

4.Install the cover.

5.Follow the procedures in After Working Inside Your Computer.

Removing the Hard Drive

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the cover.

3.Press the retention clips inwards and slide the hard-drive bracket out from the drive cage.

13

Image 13
Contents Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerClick Shut Down Installing the Cover Removing and Installing ComponentsRecommended Tools Removing the CoverRemoving the Front Bezel Installing the Front BezelInstalling The Wlan Card Removing The Wireless Local Area Network Wlan CardRemoving the Drive Cage Removing the Optical Drive Installing the Drive CagePage Removing the Hard Drive Installing the Optical DrivePry the sides of the bracket to remove the optical drive Installing the Hard Drive Removing the Intrusion Switch Memory Module Guidelines Installing the Intrusion SwitchRemoving the Memory Removing the Coin-Cell Battery Installing the MemoryRemoving the System Fan Installing the Coin-Cell BatteryRemove Cover Front bezel Drive cage Page Removing the Speaker Installing the System FanRemoving the Power-Switch Cable Installing the SpeakerRemoving the Input/Output I/O Panel Installing the Power-Switch CableRemoving the Power Supply Installing the Input/Output I/O PanelRemove Cover Page Page Lift the power supply out of the computer Installing the Power SupplyRemoving the Heat Sink Page Removing the Processor Installing the Heat SinkRemoving the System Board Installing the ProcessorPage System Board Components Power connectorProcessor Installing the System Board Page Boot Sequence System SetupFollowing table displays the system setup navigation keys Navigation KeysSystem Setup Options ATA Sata is configured for ATA mode Disabled The Sata controllers are hiddenAhci Sata is configured for Ahci mode RAID on Sata is configured to support RAID modeOptionDescription Password Change They are set. This option is disabled by defaultPermitted when an administrator password is set Is enabled and visible to the operating systemKeys will restore to default settings Reset All Keys- Resets to default settingAll Enabled by default Option is enabled by defaultAC Recovery Disabled by defaultPower loss. You can set the AC Recovery to Power Off defaultIs enabled by default Signals. For Ultra Small Form Factor onlyKeyboard Errors Sequence required to enter the Bios Boot Option MenuCommunicate. The default IP port is Software communicates. The default IP address isSerr Messages ImageServer IPJumper Settings Updating the BiosSystem and Setup Password Click Drivers & DownloadsComputer Assigning a System Password and Setup PasswordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerAmber LED State White LED State Description Possible system board resource and/or hardware failureBeep Code Error MessagesFailure Configuration Error Message DescriptionProblem Information-please Run Setup program Invalid MemoryNot a boot diskette Disk errorSystem installed on it. Insert a bootable floppy disk Value Memory sizeWrite fault on Write faultSelected drive Page Feature SpecificationsSpecification Feature SpecificationDiscrete PCI Express x16 graphics adapter Express Chipset CPU-GPU ComboIntegrated Two Channel High Definition Audio Back Panel Audio Front PanelForm factor Mini-Tower and Desktop One 36-pin connectorPCI Express x1 data width maximum one PCI Express lane Front of the computer Power button light ConnectorWhite light indicates sleep state of the computer Physical Height Width Depth Weight Power Wattage Maximum Heat Dissipation Voltage24.00 cm 30 kg 7.28 lb Inches Physical Height Width Depth Weight Ultra Small Form FactorPage Contacting Dell
Related manuals
Manual 47 pages 49.28 Kb