Dell 7010 Installing the Input/Output I/O Panel, Removing the Power Supply, Remove Cover

Page 23

4.Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and remove from the computer.

Installing the Input/Output (I/O) Panel

1.Insert the I/O panel into the slot on the chassis front.

2.Slide the I/O panel towards the left of the computer to secure to the chassis.

3.Tighten the screw to secure the I/O panel to the chassis.

4.Connect the I/O panel/FlyWire cable to the system board.

5.Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink.

6.Install the:

a)drive cage

b)front bezel

c)cover

7.Follow the procedures in After Working Inside Your Computer.

Removing the Power Supply

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

23

Image 23

Contents Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents Specifications Contacting Dell System SetupDiagnostics Troubleshooting Your ComputerBefore Working Inside Your Computer Working on Your ComputerClick Shut Down Turning Off Your ComputerAfter Working Inside Your Computer Removing the Cover Removing and Installing ComponentsInstalling the Cover Recommended ToolsRemoving the Front Bezel Installing the Front BezelInstalling The Wlan Card Removing The Wireless Local Area Network Wlan CardRemoving the Drive Cage Removing the Optical Drive Installing the Drive CagePage Pry the sides of the bracket to remove the optical drive Installing the Optical DriveRemoving the Hard Drive Installing the Hard Drive Removing the Intrusion Switch Removing the Memory Installing the Intrusion SwitchMemory Module Guidelines Removing the Coin-Cell Battery Installing the MemoryRemove Cover Front bezel Drive cage Installing the Coin-Cell BatteryRemoving the System Fan Page Removing the Speaker Installing the System FanRemoving the Power-Switch Cable Installing the SpeakerRemoving the Input/Output I/O Panel Installing the Power-Switch CableRemove Cover Installing the Input/Output I/O PanelRemoving the Power Supply Page Page Lift the power supply out of the computer Installing the Power SupplyRemoving the Heat Sink Page Removing the Processor Installing the Heat SinkRemoving the System Board Installing the ProcessorPage Processor Power connectorSystem Board Components Installing the System Board Page Navigation Keys System SetupBoot Sequence Following table displays the system setup navigation keysSystem Setup Options RAID on Sata is configured to support RAID mode Disabled The Sata controllers are hiddenATA Sata is configured for ATA mode Ahci Sata is configured for Ahci modeOptionDescription Is enabled and visible to the operating system They are set. This option is disabled by defaultPassword Change Permitted when an administrator password is setOption is enabled by default Reset All Keys- Resets to default settingKeys will restore to default settings All Enabled by defaultPower Off default Disabled by defaultAC Recovery Power loss. You can set the AC Recovery toSequence required to enter the Bios Boot Option Menu Signals. For Ultra Small Form Factor onlyIs enabled by default Keyboard ErrorsImageServer IP Software communicates. The default IP address isCommunicate. The default IP port is Serr MessagesClick Drivers & Downloads Updating the BiosJumper Settings System and Setup PasswordComputer Assigning a System Password and Setup PasswordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Possible system board resource and/or hardware failure Troubleshooting Your ComputerPower LED Diagnostics Amber LED State White LED State DescriptionBeep Code Error MessagesInformation-please Run Setup program Invalid Memory Error Message DescriptionFailure Configuration ProblemValue Memory size Disk errorNot a boot diskette System installed on it. Insert a bootable floppy diskSelected drive Write faultWrite fault on Page Feature Specification SpecificationsFeature SpecificationIntegrated Two Channel High Definition Audio Express Chipset CPU-GPU ComboDiscrete PCI Express x16 graphics adapter Back Panel Audio Front PanelPCI Express x1 data width maximum one PCI Express lane Mini-Tower and Desktop One 36-pin connectorForm factor White light indicates sleep state of the computer ConnectorFront of the computer Power button light Physical Height Width Depth Weight Power Wattage Maximum Heat Dissipation Voltage24.00 cm 30 kg 7.28 lb Inches Physical Height Width Depth Weight Ultra Small Form FactorPage Contacting Dell

Related manuals

Manual 47 pages 49.28 Kb