Allied Telesis AR400 series manual System LEDs on AR415S, Pwr, Pic

Page 24

24

AR400 Series Router

System LEDs on AR415S

The LEDs described in the following table show the operational status and port activity for the AR415S router.

LED

State

Function

 

 

 

PWR

Green

The router is receiving power and the power

 

 

switch is ON.

 

 

 

SYS

Amber

Lit briefly during router start up, or the router is

 

 

malfunctioning.

 

 

 

 

Off

Normal operation.

 

 

 

PIC 0

Green

A port interface card (PIC) is correctly installed

 

 

and has been detected by the router.

 

 

 

 

Off

No PIC is installed, or the router has not

 

 

recognised the PIC.

 

 

 

Full

Green

The link is in full-duplex mode.

 

 

 

 

Off

The link is in half-duplex mode.

 

 

 

L/A

Green

A link has been established.

 

 

 

 

Flashing

Data is being transmitted.

 

 

 

 

Off

There is no link.

 

 

 

100M

Green

The link is at 100 Mbps speed.

 

 

 

 

Off

The link is at 10 Mbps speed.

 

 

 

613-000313 Rev C

Image 24
Contents Installation and Safety Guide AR400 Series Router Table of Contents Electrical Safety Statements Package Contents Models Covered By This GuideAR440S, AR441S and AR442S Package Contents AR450S Package ContentsInstalling the AR450S Before Installing the RouterAR450S Router Selecting a SiteInstalling the Router in a Rack Applying Power to the RouterConfiguring the AR450S Using the CLI to configure the AR450SInitiate router start-up Log in and set the password Configure the routerSave the configuration Using the GUI to configure the AR450S Connect the PC to a router switch portAccess the CLI on the router Enable IP Assign an IP address to VLAN1Browse to the GUI Connecting Data Cables to the AR450S Connecting the router to your networkConnect to the LAN Connect to the DMZ portSystem LEDs on the AR450S LEDState Function Installing the AR415S AR415S RouterInstalling an Optional PIC Installing the Router in a Rack Check the supply voltage and the router’s rated voltage Configuring the AR415S Using the GUI to configure the AR415SRouter Set PC to automatic IP addressLog Using the CLI to configure the AR415S Installation and Safety Guide Save the configuration Advanced configuration At the log in prompt, enter the login name and password Connecting Data Cables to AR415S System LEDs on AR415S PWRSYS PICInstalling the AR440S, AR441S, AR442S AR440S, AR441S, AR442S RoutersInstalling an Optional PIC Installing the Router in a Rack Installing the Router on a Wall Applying Power to the Router Configuring the AR440S, AR441S, AR442S Using the GUI to configure the AR440S, AR441S and AR442SHub or Layer 2 Switch Installation and Safety Guide Set PC to automatic IP address Configure the router Using the CLI to configure the router Log in and set the password Connecting Data Cables to AR440S, AR441S, AR442S System LEDs on AR440S, AR441S, AR442S AdslShdsl Default Configuration on AR415S, AR440S, AR441S, AR442S Documentation and Tools CD-ROM Important Safety Instructions Connection to mains voltage supplyTelecommunications Interfaces Connection to Isdn network Ports for the connection of other apparatusTNV1 TNV3Safety Electrical NoticesLightning Danger Lightning Activity Electrical Type Class 1 EquipmentSicherheit Achtung Gefährliche SpannungGefahr Durch Blitzschlag VorsichtSikkerhed Elektriske ForholdsreglerFare Under Uvejr Lynaktivitet Elektrisk Klasse 1-UDSTYRVeiligheid Waarschuwingen MET Betrekking TOT ElektriciteitGevaar Voor Blikseminslag Elektrische Toestellen VAN KlasseSécurité Information SUR LES Risques ÉlectriquesAvertissement Danger D’ÉLECTROCUTION Équipement DE Classe 1 ÉlectriqueTurvallisuus Sähköön Liittyviä HuomautuksiaSalamaniskuvaara Norme di Sicurezza Avvertenze ElettrichePericolo DI Fulmini Sikkerhet ElektrisitetFare for Lynnedslag Elektrisk Type 1- Klasse UtstyrSegurança Avisos Sobre Características ElétricasAtenção Perigo DE Choque Elétrico Perigo DE Choque Causado POR RaioSeguridad Avisos ElectricosPeligro DE Rayos Temperatura Requerida Para LA OperaciónSäkerhet Tillkännagivanden Beträffande ElektricitetsriskFara FÖR Blixtnedslag Elektriskt TYP Klass 1 UtrustningFor the AR021U PIC RJ49CFor the AR440S and AR442S routers RJ11CCanadian Department of Communications Emission Compliance Statements Category Approval Agency and RequirementStandards The AR450S meets the following standards EC Declaration of Conformity We Allied Telesis Labs LimitedNazareth Avenue Christchurch 8024 NEW Zealand