Alternatively, the remote site unit can be configured by utilizing the remote configuration facility (REM) of the central site unit.
Outline of Configuration Procedure
The steps below are intended as an outline of the sequence for configuring a unit for bridging and IP. They are for guidance only and must be used in conjunction with the full description given in the following pages.
There are five basic steps for manual configuration of a unit for bridging and IP. The sequence for remote configuration of a unit necessitates a similar sequence with additional steps. The additional steps are given in “Configuring a Remote Unit from the Central Site” on page
The five basic steps for manual configuration are:
■Assign a unique name to the unit.
■Configure a unique IP address for the unit.
■Configure the ISDN network type, if required.
It is very important to assign a unique name and IP address to each unit.
■Set up the ISDN Numbers table to associate a remote unit name with an ISDN number.
■Make an entry in ISDN Autocall table to associate a unit IP address with a remote unit name.
The three Quick Configuration steps are:
■Assign the unit name, configure the unit IP address and the ISDN network type (if required).
■Specify the ISDN number of the central site unit.
■Make a manual call to the central site unit, if required.