3Com 980-000077/002 manual Configure the Isdn Numbers Table on the Central Site Unit

Configuring a Remote Unit from the Central Site 4-9

Configure the ISDN Numbers Table on the Central Site Unit

A new entry must be added to the ISDN Numbers table on the central site unit, giving the name that the remote unit will have once that unit has been fully configured, and the ISDN number for the unit.

1Enter CO IS NU to display the ISDN Numbers screen.

2Enter ADD to add a new entry to the numbers table.

3Type the name assigned to the remote unit in the Name field and the ISDN number for that unit in the ISDN Number 1 field.

Do not alter the IP Address, IP Mask or IPX Network fields. Unit names are case-sensitive and must be entered correctly.

4Press [Ctrl]+[E] to submit the new setting and then enter SAVE

Establish a Remote Management Session

A manual call must be placed before the configuration of the remote unit can proceed.

1Enter CO IS NU to display the ISDN Numbers table.

2Select the entry for the remote unit using the Arrow keys and enter

CALL

3Enter REM to display the Remote Units screen. Press [Ctrl]+[V] at regular intervals to refresh the screen, until an entry for NoName 10.0.0.1 appears.

4Select the NoName 10.0.0.1 entry using the Arrow keys and enter

REM

5The Enter Password screen on the remote unit should be displayed within 30 seconds.

■If the Enter Password screen is not displayed, check that the name and IPX network address for the remote unit have been entered correctly on the central site unit and that the ISDN line is connected and working normally at both ends of the link.

6Enter PASSWORD (in upper-case letters) when the Enter Password screen is displayed.