Configuring a Remote Unit from the Central Site |
Close the Remote Management Session
1Enter QUIT to terminate the remote configuration session. Press [Ctrl]+[D] if this command is not available.
The Remote Units screen on the central site unit is displayed.
Cancel the Manual Call
It is important to remember that a manual call is still running from the initial connection to the remote unit. The call must be cancelled manually.
1Enter CO IS NU to display the ISDN Numbers screen.
2Select the entry for the remote site unit and enter CANC to cancel the call.
3Enter SAVE to save the new configuration.
All manual calls must be cancelled when the unit configuration is complete. A “call guillotine” operates after 60 minutes (the default setting) to cancel the calls but during this time additional, unnecessary, call charges will have accrued.
To ensure that all ISDN calls are cancelled, follow the sequence of steps described in “Cancelling ISDN Calls” on page
It is good practise to enter SAVE to save the “new” configuration.
Test the IPX Autocall Table
To test that the IPX Autocall table is functioning correctly, run a Novell client on a computer at the remote site to see if that client can access the server located at the central site.
Cancelling Calls
To cancel all of the ISDN calls, follow the sequence of steps described in “Cancelling ISDN Calls” on page